Municipal Administration And Water Supply Department Tender

Plain Cement Concrete 1:4:8 (one cement four fine aggregates and eight coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification

Supplying and filling in foundation and basement with Well Gravel in layers of not more than 15cm thick well rammed watered and compacted etc., complete complying with standard specification.

Supplying and erecting centering for sides and soffits including necessary supports and strutting upto 3.29 M height for plane surfaces as detailed below in all floors with all cross bracings using Mild Steel sheets of size 90 x 60 cm and 10 BG stiffened with welded Mild Steel angle of size 25mm x 25mm x 3 mm for boarding laid over silver oak joists of size 10cm x 6.50 cm spaced at abote 90 cm centre to centre and supported by casurina props of 10cm to 13 cm dia spaced at not more than 75 cm centre to centre etc. complete complying with the standard specificaiton. (Payment for centering shall be given after the concrete is laid) - Centering For Rectangular or Square Column

Centering For Plinth beam and Lintel Beam

Centering For Bottom only

Providing and laying in position Standardized Concrete Mix M-20 Grade in accordance with IS 456- 2000 using 20mm and downgraded hard broken granite stone jelly for all RCC of works with minimum cement concrete 0f 325 kg/m3 and maximum water cement ratio of 0.55 including admixture ( Plaster / super plasticizer ) in recommended proportions as per IS : 9103 to accelerate, retard setting of concrete improve workability without imagining strength and durability with about (5.0cu.m) 7730 kg of 20mm machine crushed stone jelly and with about (3.3 cum) 5156 kg of 10-12mm machine crushed stone jelly and with about (4.79 cum) 7670 kg of sand, but excluding cost of reinforcement grill and fabricating charges centering and shuttering and also including laying vibrating with mechanical vibrators finishing curing etc. and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra, etc,. Complete complying with standard specification and as directed by the departmental officers the coarse and fine aggregates to be used should comply with the requirements of IS Standards. (No separate payment will be made by the Department for the excess usage of materials). - For Foundation & Basement

For Grond Floor

Suppling and fabricating and placing in position MS (or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors.

Brick work in CM 1:5 (one cement & five sand) using III class country bricks of size 83/4"X41/4"X 2 1/4" including finishing, curing, etc., complete complying with standard specification - 100CFT - For Basement Floor

For Ground Floor

For First Floor

Plastering with cement mortar 1:3, 10 mm ,thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications (S.I.306)

Plastering with cement mortar (1:5) 12mm ,thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications (S.I.306)

Weathering Course with Concrete Broken Brick (S.I.No.278) & ( P & D) Data 54.Jelly 20mm gauge in pure slaked lime (no sand to be added) over roof slab,the proportion of brick jelly to lime being '32 to 12.5 well beated with wooden beaters for giving required slope and thickness as directed by the departmental officers etc., complete.-10

Finishing the top of roof with one course of machine pressed tiles of size 200 mm x 200 mm x 20 mm of approved quality in Cement Mortar 1:3 (One Cement add three sand) 12 mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete

Supply and Delivery Fabrication of MS Doors with outer frame and shutter frame in MS angle of size 40mm x 40mm x 6 mm with MS flat 25mm x 25mm x 6mm and MS sheet of 18 gauge including ventilating arrangements using 20mm square MS rods with locking arrangements including two coats of approved enamel paint over coat of red oxide including cost of angles, plates, sheets, fabrication charges, cost of hold fast and transportation charges etc., complete. - Fully panelled Single leaf - Door

Fully panelled Double leaf - Window (without Ventilator)

Finishing the top of floor with Granolithic Finish with CC 1: 2: 4 (one cement, two sand & four HBG jelly) using chips of grade 10 mm and below for 25mm thickness and rubbed smooth etc, complete as per standard specification

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated Single Core unsheathed Copper Conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessoires with Module GI switch box in flush with wall with 6A one way module switch front plate continuous earth connection of 14SWG TC wire and making good of the concealed portion with suitable colour for concealed PVC light / Fan Point (For electronic regulator) (6 Points Per Coil) SD -314

Supply and fixing of single box type (philips / Havells / Eq) suitable for 4 feet 20W LED tube light with TW round blocks on wall or ceiling with 20W LED tube light with PVC unsheathed Copper leads from terminals to

Supply and fixing of 1200mm (48") sweep AC ceiling fan (Crompton / Havells / Usha / Equivalent) with 2 module 100W regulator complete with 300mm down rod on existing clamp SD 111

Painting two coats with ready mixed Plastic Emulsion Paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification. - 10 sq.m

Painting with Ready Mixed Enamel Paint over the new Iron works of approved quality and colour with priming coat including the cost all materials etc., complete, in all floors.

Add GST 18%