Municipal Administration And Water Supply Department Tender

Supply and fixing of single box type (philips / Havells / Eq) suitable for 4 feet 20W LED tube light with TW round blocks on wall or ceiling with 20W LED tube light with PVC unsheathed Copper leads from terminals to the fitting

Supply and fixing of 18W LED Recessed square type LED of 18W CDL (philips / Havells / Eq) suitable for false ceiling with inbuilt driver and diffuser with connection complete

Supply and fixing of 1200mm (48") sweep AC ceiling fan (Crompton / Havells / Usha / Equivalent) with 2 module 100W regulator complete with 300mm down rod on existing clamp

Supply and fixing of 3No's of 2 module 6A/16A 2 module combined flush type wall socket with 1 module 6A and 16A control switches concealed in 18 Module metal box covered with suitable coverplate in flush with wall with earth connection

Supply and fixing of 20AmpsDP Plug and socket in sheet steel enclosure with 32 A DP MCB in flush with wall with earth connection. (Legrand (MDSS/Haser) (L&T ) (SD -140)

Supply and fixing of 6A/15A 3pin combined flush type wall socket with 15A flush type modular switch concealed in suitable Module metal box covered with suitable coverplate in flush with wall with earth connection

Supply and fixing of 375mm (15") sweep Heavy Duty AC Exhaust fan Complete with Necessary wal Opening and making good of the wall

Supply and fixing of louvers shutters arrangements for 375mm (15") sweep light duty AC Exhaust fan

Supply and fixing of vertical type TPN MCB DB of Single / Double door type with metal door with IP 42 Protection with 1 No 32A FP MCB Isolator as incoming and 1 No 30MA FP RCCB / ELCB as sub incomming and 12 No 6A to 32A SP MCB as outgoing in flush with wall and making good of the conceeled protion with earth connection The MCB DB and MCB's should be of legrand / Hager (MDS) Make

Supply and run of 2 of 4 sq.mm (56/0.30 PVC insulated SC unsheathed copper conductor of 1100v grade in suitable PVC rigid pipe concealedl in wall and ceiling with continuous earth wire connection of 14 SWG TC wire and making good of the conceded Portion with suitable Colour (SD -57)

Supply and laying of 31/2 x 25sq.mm LTUG PVC armoured cable in a trench to be excavated at depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good (SD-204)

Supply and fixing of brass cable gland for 31/2 x 25 sq.mm PVC armoured LTUG Alu. Cable with earth connection (SD -186)

Supply and providing cable end termination of 31/2 x25 sq.mm PVC LTUG aluminium armoured cable with necessery Alu. Cable socket by crimping etc., with electrical connection complete. (SD -235)

Supply and clamping of 31/2 x 25 sq.mm PVC LTUG armoured Alu. Cable on post or on wall with MS Clamps (SD-222)

Supply and clamping of 31/2 x 25 sq.mm PVC LTUG armoured Alu. Cable through suitable G.I pipe on wall with MS Clamps

Supply, fabrication, of 200A Capacity Dust and vermin proof cubical type metering panal board Size of 3480mm(L) x 1725mm(H) x 0.300mm (D) made up of 16 SWG CRCA sheet steel for outer body Doors, switch and KWH meters, Separation, supports and with supply and fixing of four pole MCB isolator, and re wireable fuse units with bus bar chamber complete with tinned copper flat for three phase and netrual with bus bar insulator complete with inter connection of WH meters, current carrying capacity multi standard PVC insulated copper wire between bus bar to WHM and WHM to cutout and MCB's tinned copper flat for earth bus runs all round the panel to provide earth connection by by No.8 SWG HDBC conductor to incoming Fuse and meter chamber bus The housing the accommodate 28 No's Three phase WHM 200A Fuse with 100A Neutral Link as incomer 40A FP MCB 14 No's (MDS/ Legrand/ Hager/ L&T) and with sectional cutout for 3No's of 32A fuse in 28No's as Section cutout for each service WH metering chamber cutouts chamber suitable for WHM connecting 3 phase 4 wire reading type meter

chamber at the front for reading type meter chamber provided with 5mm thick transprant glass at the front for reading purpose with sealing provision by TNEB and supply the panel board should be painted two coats of High quality epoxy paint over one coat of red oxide primer with superscriptions the above cubical EB metering panel rest on Suitable angle iron baseEarthing as per the ISI specification with an earth electrode of 2.1mt class 'B' GI pipe of dia not less than 40mm, with copper earth plate of size 125mm x 50mm x 6mm, with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry . (SD -233)

Supply and run of 1 of No.8 SWG GI wire for earth connection. (SD -74)

Add GST 12%