Municipal Administration And Water Supply Department Tender

Supply and fixing of three phase service connection EB Meter box of size 15"x14"x9" with single compartment made up of 16SWG powder coated vermin proof metal sheet with clamps suitable for EB RCC pole suitable for single phase EB service connection. The meter box fixed with 12mm wooden board fixed with one number of 63 Amps porceline fuse unit Inter connection with 7/20Amps PVC insulated copper wire with one number of neutral link. The meter box should be provided with glass in front side. fixing of The meter box should be made PWD earthing. The rate includes dismanling of existing meter box and fixing new meter box, EB energy meter and accessories and termination of wires.

Supply and Laying of 3.5x25Sq.mm PVC armoured LTUG Cable and 40 mm HDPE pipe in a trench to be excavated at a depth of 0.75 Metre putting 0.10 Metre.Layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good.

Supply and run of 10 of 4 sq.mm. (76 / 0.3) PVC insulated single core unsheathed copper conductor of 1100V grade on 7 / 20 GI bearer wire for service connection mains (SD-67)

Supply and Installation of Three Phase Street Light controller with RF based Gateway controller Device capability of scheduling the on/off timings of lighting control switchgears based on present timings or based on the available annual sun-rise and annual sun-set timings with GPRS/GSM based remote street light monitoring system with capacity for self-protection from short-circuit, over voltage and anti-theft alert including the 1)System capability to capture and provide following parameters at variable time-intervals a) Live data collection of : b) Voltages c) Current d) Power Factor e) Active Power (kW) f) Metering kWh cumulative g) Number of hours the lamps were glowing 2) Special emergency on/off facility with wireless control 3) Benchmarking capacity so as to generate alert message for: 4) Alert notifications shall be forwarded to android apps. 5) Alert for Door open. 6) Enclosure Box to be IP55 complaint and in case of Metal enclosure has to be corrosion-resistant. 7) 4G modem used should be a Dual-band modem with power consumption less than 5 watts. 8) Energy Meter with ISI marking should be used for power measurement. Class 1.0 accuracy or better energy meter to be used. 9) The rating of the Street Light controller should be at least two times the lighting load. 10) The Street Light Controller should have inbuilt RF Gateway device to be used in conjunction with Individual Lamp Monitoring (ILM) devices for future proof. 11) Design life should be more than 10 years. 12) IN built GATEWAY SPECIFICATIONS. a) Processor : Single board computer. b) Power supply : 90 VAC, 50 Hz c) Surge

Supply, delivery of 150W LED Flood Light Lumens