Hindu Religious Institutions And Charitable Endowments Tender

Cement Concrete 1:5:10 (One Cement, Five sand and Ten hard broken stone jelly) using 40 mm gauge hard broken granite stone jelly for foundation including dewatering wherever necessary and laid in layers of not more than 15 cm thick well rammed, consolidated and curing etc. complete complying with standard specification

Providing and laying in position, Standardised Concrete Mix M-20 Grade in accordance with IS:456-2000, using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement content of 325 kg/mᶾ and maximum water cement ratio of 0.55, including admixture (plasticiser / super plasticiser) in recommended proportions as per IS:9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability with about (5 cu.m.) 7730 kg. of 20mm machine crushed stone jelly and with about (3.3 cu.m.) 5156 kg. of 10-12mm machine crushed stone jelly and with about (4.79 cu.m.) 7670 kg. of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing, etc. and providing fixtures like fan clamps in the RCC floor/ roof slabs wherever necessary without claiming extra, etc., complete complying with standard specification and as directed by the departmental officers. The coarse and fine aggregates to be used should comply with the requirements of IS Standards. (No separate payment will be made by the Department for the excess usage of materials).

Foundation and Basement

Above Basement upto 4.50 m

Above 4.50 m height

Supplying fabrication and placing in possition of MS or RTS bars for all RCC works including cutting bending placing and the cost of binding wire etc., complete.

Centering for soffis of RCC slab of plane surface Iike lintel,beam etc.,including strutting 3.0m height using M.S.sheets of size 90 x 60cm and BG 10 stiffener with M.S.Angles of size 25x25x3mm laid over silver oak (CW) joists size 10cm x6.5 cm (spaced at about 90cm c/c) and supported by Casurina prop. 10cm to 13cm dia ( spaced of 75cm C/C) complying with standard specification.

(A) Foundation and Basement

(B) Plain surfaces

(C) Column

(D) Kodungai

Providing additional strutting to centering of RCC slabs of plain surface for every additional 1.0 metre height or part thereof but not less than 30 cm, over the initial 3.00 metre height from floor level using casurina props of 10cm to 13cm dia including cross bracing etc., complete complying with standard specification and as directed by the department officers.

Brick masonry Lime mortar 1:2 using Chamber Burnt Bricks II Class(Ground Moulded) 9" x 4 3/8" x 2 3/4" including all varivargams, moulds, sthambams, mukapathrams, koodu, nasi and all ornamental brick work complete, all pancharams, agarais, karnakoodus, etc., forming core walls of Rajagopuram/ Vimanams complete including cost and conveyance of all materials including cement, all the labour charges including marking pathies shaping of the bricks, lifting of all the materials to required heights, curing and all extra for working in heights etc., complete 100 cft for vimanam / gopuram. The lime used should be sourced from Pollachi which is highly iron fortified and suitable for structural and masonry works.

Providing Vargapoochu over the corewalls of Vimanams / Gopurams, with Lime mortar 1:1.5 complete including shaping the mukhapathram, mahanasi, Koodu all ornamentals works to proper shape by embedding broken bricks of shaped/chiseled bricks, rough-plastering with Lime mortar 1:1.5 and finishing with final ornamental plastering and nayam theervani including cost and conveyance of all materials, labour therefore, lifting of materials, all working in heights, curing with water etc, complete including all extra for folding and including clearing from the vimanams/gopurams 100sft superficial area. for kalkaram The lime used should be sourced from Pollachi which is highly iron fortified and suitable for structural and masonry works.

Excluding Kalkaram

For Kalkaram

Providing new sudhai vigrahams in the vimanams and Rajagopurams with galvanised iron rod reinforcement of suitable dia with binding wires wherever necessary, shaping the core with broken bricks set in Lime mortar 1:1.5 finishing the same with Lime mortar 1:1.5 bringing to the correct shape (Lakshana) in conformift with silpa sastra inclusive of special ornaments, wiapons, peedam etc., complete and providing C.M. Nayam theervai wherever necessary. inclusive of cost and conveyance of all materials, such as cement broken bricks, and G.I. rods.binding wire all labour for working in heights, curing lifiting of materials etc., complete including Panchavarnam 2 coats over a primary coat (one vigraham is accountable with one head, 4 hands with weapons, ornamental costumes etc., as per prathima lakshans, Vigraham height is measurable from the crown top to the bottom of foot only If peetam is provided the rate with peetam may be adopted as datailed hereunder) The lime used should be sourced from Pollachi which is highly iron fortified and suitable for structural and masonry works.

Sudhai vigrahams of ht 1’0” – 2’6”

Sudhai vigrahams of ht 2’6” – 3’6”

Brick work in following Lime mortar 1:2 using best quality of country bricks of size 8-3/4" x 4-1/4" x 2-3/4" for foundation and basement including curing, etc., complete complying with standard specifiction.

Plastering with Cement Mortar 1:5 (One cement and Five sand), 12mm thick in all floors including curing etc. complete complying with standard specification and as directed by the departmental officers.

Special ceiling plastering and finishing the exposed surface of all RCC items of work such as slabs, beams, sunshades, facia, canopy slab, staircase waist slab, landing slab etc., with Cement Mortar 1:3 (One Cement and Three Sand) 10mm thick including hacking the surfaces, providing cement mortar nosing, beading for sunshades, staircases, steps, landing slabs and curing, etc., in all floors complying with standard specification and as directed by the departmental officers

Painting two coats of newly plastered wall surface with Water based emulsion paint of first class quality and of approved colour over a priming coat including thorough scrapping, clean removal of dirt, and including necessary plaster of paris putty, wherever required etc., complete complying with standard specification.

Painting with Water based exterior emulsion paint (multicolour - Panchvarnam) complete for the Vinamans/Gopurams, inculding cost and conveyence of all materials, lobour charges inculdinf Artist painter, working in heights, lifting of material, cost of brushes etc, complete-which including all extra for foldings-100sft, superficial area.

Flooring with cutstone slab of size 600 mm x 600 mm and other sizes suitable for site requirement not less than 100 mm thick with machine cut edges and top surface dressed as directed by the departmental officers including cost and conveyance of materials to site and labour charges for paving and Pointing with Lime mortar 1:1.5 etc., complete

Weathering course in brick jelly lime concrete using broken brick jelly of size 20mm uniform gauge in pure slaked lime (no sand to be used) to the proportion of brick jelly to lime being 32:12.5 by volume and laid over the RCC roof slab in a single layer of required slope and finished by beating the concrete with wooden beaters of approved pattern, keeping the surface constantly wet by sprinkling lime jaggery water, etc., complete as per standard specification and as directed by the deparmental officers.

Finishing the top of roof with one course of machine pressed tiles of size 230mm x 230mm x 20mm of approved quality set in Cement Mortar 1:3 (One Cement and Three Crushed stone Sand) 12mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete complying with standard specification and as directed by the departmental officers

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated single core unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessoires with Modue GI switch box in flush with wall with 6A one way module switch with front plate with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for Concealed PVC light point/ fan point (for electronic regulator) (5 points/ coil) Lower end (Data- A-1)'

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated single core unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories with suitable Modue GI switch box in flush with wall with 1 no. 6A one way module switch and 1 no. 6A 3/2 pin module socket with module front plate with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with painting of suitable colour for Concealed PVC pipe plug point (8 points/ coil) Lower end (SD 317)

Supply and fixing of 4 feet single Box type fitting with 4' 20W LED tube with TW round block on wall or ceiling with PVC unsheathed copper leads from terminals to the fitting (Data -A 2)

Supply and fixing of 1200mm (48") AC ceiling fan complete with stepped electronic 300W regulator with 300mm down rod on the existing clamp (SD 110)

Supply and fixing of 32A DP MCB with sheet steel enclosure on wall with earth connection (Lower end) (Data -A3)

Supply and run of 2 of 4 sq.mm. (56 /0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour (SD 57)

Supply and fixing of 8 way single pole and neutral MCB sheet steel enclosure distribution board with double door (metal) with 1 no. 40 A DP MCB Isolator as incoming and 6 nos. 6A to 32A SP MCB as outgoing in flush with wall with earth connection only. Lower End (SD 602)

Earthing as per PWD standard with an earth electrode of 2 metre Class ‘B' GI pipe of dia not less than 32mm complete with necessary masonry work (SD 234)

Supply and run of 1 of No.8 SWG Gl wire for earth connection (SD 74)

Supply and fixing of 48W LED street light fitting with LED (Higher end) with 32mm dia. Gl pipe (class B) with 1 n0.32 mm GI bend complete on the existing post/ on wall with PVC unsheathed copper leads with MS clamps and with painting .(SD 535)

Supply and fixing of 65 mm dia. (2 -1/2") Gl pipe (class B) of 6 metre length with 300mm x 300mm x 6mm MS base plate duly welded at the bottom with concreting with construction of masonary pedestal with suitable SMC box with door arrangement to house 6A SP MCB switch, 2/4 way connector on suitable hylem sheet and supply and fixing of 48W LED street light fitting with LED (Higher end) with 1 metre 32mm dia. Gl pipe (class B) Complete with suitable MS clamps for LED steet light fitting and SMC box with PVC unsheathed copper leads from SMC box to fitting and with painting of suitable colour .(SD 543)

Supply and laying of 2 x 6 sq.mm PVC armoured LTUG cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good (SD 197)

Supply and clampingof 2 x 6 sq.mm. PVC LTUG armoured cable on post or on wall with MS clamps (SD 215)

Supply and clampingof 2 x 6 sq.mm. PVC LTUG armoured cable in suitable Gl pipe on post or on wall with MS clamps (SD 215 + cost of 25mm dia Gl pipe)

Supply and fixing of brass cable gland for2 x 6 sq.mm. PVC LTUG armoured cable with earth connection (SD 181)

Supply and fixing of 32A DP MCB , 4 way connector with base tin channel housing in SMC box for street light control (Data A 4)

Supply and fixng of TNEB meter board suitable for 3 phase 100A service connection made up of suitable angle iron frame work of size 2 feet x 1-1/2 feet using angle iron of size 1-1/2" x 1-1/2" x 1/4" rigidly fixed on wall covered with hylem sheet of size 2 feet x 1-1/2 feet of 12mm thickness with necessary bolts and nuts supports and supply and fixing of 3 Nos. 100A fuse units (500V), 1 No. neutral link, copper earth flat of size 1" x 1/4" with inter connection of EB meter to fuse units by 16 Sq.mm PVC insulated copper wire with earth connection complete (SD 130)

Supply and fixing of 3 phase 100A aerial fuse unit for 3 Nos. 100A fuse units (500V) on suitable MS sheet covered with 6 mm thick hylem sheet on suitable angle iron work the tapping pole with necessary clamps (Data -A5)

Supply and fixing of 100A TPN sheet double break switch with HRC fuse and neutral on suitable angle iron frame work with earth connection only (SD 169)

Supply and laying of 3 1/2 x 50 sq.mm PVC armoured LTUG cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good (SD 206)

Supply and clamping of 3 1/2 x 50 sq.mm. PVC LTUG armoured cable on post or on wall with MS clamps (SD. 224)

Supply and clamping of 3 1/2 x 50 sq.mm. PVC LTUG armoured cable in suitable GI pipe on post or on wall with MS clamps (Data- A6)

Supply and fixing of brass cable gland for 3-1/2 x 50 sq.mm PVC armoured LTUG cable with earth connection (SD 188)

Supply and providing cable end termination of 3-1/2 x 50 sq.mm PVC LTUG aluminium armoured cable with necessary aluminium cable sockets by crimping etc., with electrical connection complete (SD 237)

GST Amount for providing Service to Government Contract Works for the above works at 18%(9%+9%). {GST Amount is the Total GST Amount for overall quoted amount}