Directorate Of Town Panchayats Tender

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X 10cm and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed (SI 154-A) Footing,Grade & Plinth Beam

Columns

Providing and laying in position Standardised Concrete Mix M-20 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 325Kg/ cum and maximum water cement ratio of 0.55 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of sand, but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers - The Coarse and Fine aggregates to be used should comply with the requiremnents of IS staandards. (No separate payment will be made by the Department for the excess usage of materials)

Suppling and fabricating and placing in position MS (or) R.T.S. bar for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors.

Brick work in following Cement Mortar using best quality of Country Bricks of size 8-3/4" x 4-1/4" x 2-3/4" for foundation and basement including curing, etc., complete complying with standard specifiction.

Plastering with cement mortar 1:5 (One cement and five sand) ,12 mm ,thick in all floors including cost and conveyance of all materials to site etc,complete as per standard specifications

Painting two coats of newly plastered wall surface with ready mixed plastic emulsion paint of first class quality and of approved colour over a priming coat including thorough scrapping, clean removal of dirt, and including necessary plaster of paris putty, wherever required etc., complete complying with standard specification.

Supplying and fixing of M.S grill of approved design for doors, windows and ventilators using necessary mild steel flats for inner and outer memebers which should be fixed to window frames inclusive of priming coat of best approved quality red oxide primer etc., complete complying with standard specifications.

Painting Two Coats on new Iron works with best synthetic enamel paint of approved colour and quality – 10m2.

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X 10 cm and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists

Plain Cement Concrete 1:2:4 (one cement, two fine aggregates and four coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per st

Providing and laying, spreading and compacting graded stone aggregate to Wet mix macadam (WMM) specification including premixing the material with water at OMC in mechanical mix plant carriage to mixed material by tipper to site laying in uniform layers w

Supplying and laying Rubberised interlocking Paver block M40 grade 63mm thick high strength type conforming IS 15658-2006 of rubberized interlocking paver lock in size of minimum compressive strength of 40N/mm2 in uniform shape of approved make to be la

Supply and fixng of TNEB meter board suitable for 3 phase 100A service connection made up of suitable angle iron frame work of size 2 feet x 1-1/2 feet using angle iron of size 1-1/2" x 1-1/2" x 1/4" rigidly fixed on wall covered with hylem sheet of size 2 feet x 1-1/2 feet of 12mm thickness with necessary bolts and nuts supports and supply and fixing of 3 Nos. 100A fuse units (500V), 1 No. neutral link, copper earth flat of size 1" x 1/4" with inter connection of EB meter to fuse units by 16 Sq.mm PVC insulated copper wire with earth connection complete (SD-130)

Earthing as per the ISI specification with an earth electrode of 2.10 metre Class 'B' GI pipe of dia not less than 40mm with copper earth plate of size 125mm x 50mm x 6mm with necessary funneling arrangements with necessary masonry work and with 38mm RCC cover slab for the brick masonry (SD-233)

Supplying and fixing of 6 Metre Length Single Bracket Pole with Base Plate (250 x 250 x 6mm) 76.10mm OD x 3.65mm Thick x 6000mm Length (PWD SOR PAGE. 148)

Supplying and fixing of SINGLE PHASE DISTRIBUTION BOARD 4 ways single phase DB No. of ways incomer MCB / Isolator - 2 No. of ways incomer ELCB / RCD - 2 No. of outgoings ways - 2 (PWD SOR PAGE. 139)

Supply and laying of 2 x 6 sq.mm PVC LTUG aluminium armoured cable in a trench to be excavated at a depth of 0.75 metre putting 0.15 metre layer of sand and covering the cable completely with bricks and sand and refilling the earth to make good (SD-197)

Supply and delivery of MS Kiosk of size 0.75m x 0.45m x 0.75m made up of MS angle of size 50mm x 50mmx 4mm alround covered with 16 gauge MS sheet and kiosk door made up of MS plates of size 25 mm x 3 mm including cutting, welding, grinding, locking arrangements and labour charges etc., TWAD SOR P.NO. 85

Supplying and fixing of 30W LED Street light fitting with LED outdoor fittings Higher end philips/havells/Equivalent etc complete. Pwd sor page 115

Investigation charges for Geophysical survey for locating the bore well including cost of all labour charges etc., complete as per standard specification.

Drilling 150mm deep vertical bore well in all clause of soils /hard rock area including all transportation charges of rigid and labour charges etc complete

Supply and delivery of 180m PVC casing pipe including cost and conveyance of all meterials to site etc complete

Wiring with 2x1.50 Sqmm (22/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100 V Grade in suitable PV C rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A F.T. Switch with painting of suitable colourful Open PV C light point ( For electronic regulator ) (5 points per coil) SD-18

Wiring with 2x1.50 Sqmm (22/0.3) PVC insulated unsheathed Cu. Conductor of 1100 V Grade in suitable PV C rigid pipe on wall and ceiling with PVC accessories with 150 x 100 x 113mm TW switch box for 5A 3 pin non inter locking CS Plug with painting of suitable colour with continuous earth wise connection of 14 SWG TO and with TCwire for open PVC Plug Point.SD-36

Supply and fixing of 16 Amps DP Switch metal clad of 500 V with fuse and neutral (Side Handle) on suitable TW Box PWD Earthing SD-141

Supply and Delivery of 1.00 HP wet type submersible pump set 50lpmX40m head, confirming to IS 8034/89 with ISI marking along with 2.5 sq mm. cable (to 5m lengh) suitable for installation in 150 mm dia bore including Transportation charges etc., complete

Supply and delivery of 1.00 HP panel board suitable for above pump set with all accessories as per IE rules with Is specifation ect., complete

Supply anddelivery of 63mm HDPE hose including cost and conveyance of all materials to site and all labour charges etc.,

Supply and delivery of 2.50 sqmm Copper Cable including cost and conveyance of all materials to site and all labour charges etc.,

Supplying and fixing of 1'' Dia G.I. Service pipe including cost and conveyance of all materials to site and all labour charges etc.,

Supply and fixing of 32 Amps fuse carrier including cost and conveyance of all materials to site and all labour charges etc.,

Supply and fixing of 18Watts Power saver light fitting including cost and conveyance of all materials to site and all labour charges etc.,

Supply and delivery of 1000 litres HDPE Tank including cost and conveyance of all labour charges etc, complete

Supply and run of 3 of 4 Sqmm (56/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V and grade in suitable heavy gauge M.S. Conduit pipe on wall and ceiling with continued earth wire connection of 14 SWG TC wirewith painting of suitable colour.SD-47

Labour charges for erection of 1 HP Submersible motor including cost of all charges etc, complete