Urban Improvement Trust Tender

Construction of 0.30 wide + 0.15 Mtr. Thick wall with stone & brick masonry mixed for proper leveling under railing work should be completed with CM 1:4 & Plaster work in cement sand mortar 1:3 with thikness of 12mm. The top of aboe wall should be completed with 100mm thick RCC by using minimum rainforcement & one visible side completed by Bamboo/Ballie desing desing and drawing approved by Engrineer incharge.

Making of railing as per following Specifaion desing 2. Nos. vertical pole should be made in 1.0 mtr Distance & 1.0 Mtr. Height and also of 3" thikness. 2 Nos. cross pole should be made per above specification 1 Nos. horizontal pole should be use made on top side as per above specification3 Nos. 8mm size bars should be use every pole with 6 nos. ringhs of 4m. G.I. Wire The Stainless steel murga jhali should be fixed with every pole for C.C. Work. All poles should be complete by 1:1:2 R.C.C Mixture The Plaster work should be complete by 1:2 mortar of not less than 12 mm thick. Finishing work should be complete by white cement oxide colours as per direction & made the pillar in Bally or Bamboo desing or as per deriction after finishing work should be done two couts of touch wood. Work should be done as per direction of incharge.

Construction of Gate as per following specification and as per Design and drawing approved by Engineer Incharge. 4 Nos. pillar as per design & drawing should be made by 1:1:5:3 RCC with nominal reinforcement of 10,8,6 mm dia. All pillar's should be constructed not less than 8'-0'' from ground level. 1 No 10'-0'' long slab cast after 8'-0'' clear height of Pillar min 3'-0'' wide & 4'' thickness completed by 1:1:3 RCC having suitable rainforcement design and drawing approved by Engineer Incharge. No. 8'-0'' long slab cast on 1 slab & 4 Nos. pillars not less than 2'-0'' height of 4'' thickness by using 1:1:5:3 RCC nominal rainforcement required. Finishing work should be complete in wooden design/ Bamboo design/ ballies design etc. as per enclosed photograph. Complete with oxide colour & touch wood for fine finishing all work should be completed as per direction of Engineer Incharge.