Maharana Pratap University Of Agriculture And Technology Tender
If you're looking for Rajasthan tenders online and are tired of typing tender ID over and again or going through the cumbersome government websites for it, you are in luck. We have collated every Eproc Rajasthan tender on BidAssist. And for any queries related to an e-tender Rajasthan, like bidding process, registration process, etc., are explained below. Read on.
Costs
EMD
₹ 12,600Document Cost
₹ 500Tender Fee
₹ 500
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2022_MPUAT_287027_6Bid Award Id
ViewTender No
E-NIT 05 (2022-23) EO MPUAT UdaipurTender Authority
Maharana Pratap University Of Agriculture And Technology ViewPurchaser Address
-Website
http://https://www.mpuat.ac.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
Random rubble stone masonary for foundation and plinth in cement sand mortar above 30 cm thick wall in: Cement mortar 1:6 ( 1 Cement : 6 Sand )
23
-
2072
Cement concrete flooring grade 1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate) rounding off edges etc. but excluding the cost of nosing of steps etc. complete:75mm thick with 20mm thick nominal size aggregate with Neat cement punning
40
-
414
Random rubble dry stone kharanja under floor
7
-
979
Providing and laying in position cement concrete including curing compaction etc. complete in specified grade, excluding the cost of centering and shuttering – all work up to plinth level using crusher broken aggregate M-20 grade Nominal Mix [with graded stone aggregate 20 mm. nominal size]
1
-
4275
Structural Steel work welded in built up sections, trusses and frame work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete above plinth level upto 4.5 m. height in flats,tees, angles and channels.
550
-
81
Steel work in built up tubular trusses including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer welded and bolted including special shaped washers etc. complete above plinth level upto 4.5 m. height : Hot finished welded type tubes
360
-
112
Providing and fixing steel gate, grating and grills made of angles, tees, square bars or other flats,or black pipe with hold fasts and fittings complete as per design and drawing including cutting, welding and fabrication with priming coat of red oxide.
330
-
83
Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %), total coated thickness with zinc coating 120 grams per sqm as per IS:277 , in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. the sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.
45
-
599
Supplying and fixing fixed wire gauge of 14 mesh x 24 gauge to the metal frame of rolled section by metal beading 20 x 3 mm. with suitable screw at not exceeding 150 mm. distance.
3
-
501
Plaster on new surface on wall in cement sand mortar 1:4 including raking of joints etc. complete fine finish: 25mm thick
50
-
209
Repair of existing steel glazed doors, windows and ventilator, MS sheet door, garage doors, compound wall gates etc. by welding drilling complete include. Cost of welding rods and hire charge of welding machine and TP etc complete
9
-
168
Providing and fixing welded mesh/expanded metal mesh in frame work, flat iron beading 20x3 mm including top cross laps inside and out sides welding, iron bolts, screws, clips etc. complete (Excluding frame work) of size. Welded mesh 25x25mmx16 gauge.
42
-
556
Wall painting with plastic emulsion paint of approved brand and manufacture to give an even shade : two or more coats on new work including preparation of base with primer, putty, lippy complete in all respect
100
-
92
Painting with Enamel paint of approved brand and manufacture to give an even shade:- Two or more coats on New work
80
-
78
Supplying and fixing of chain link fencing with angle iron posts 50x50x6mm placed at every 3 Mtr. apart 30cm in ground embedded in cement concrete 1:3:6 (30x30x45cm) corner and every tenth post to be strutted with (50x50x6cm) angle iron provided and fixed and fitted with posts including earth work in excavation etc. complete with chain link size. 50mmx50mmx3.15mm
650
-
485
Add or deduct for each wire line
1850
-
10
Add for using galvanized barbed wire instead of black barbed wire.
1850
-
2.5
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements