Bhiwadi Integrated Development Authority Tender

Providing and fixing of Precast concrete interlocking blocks of manufactured from fully computerized automatic stationery hydraulic vibro pressed machine & full computerized automatic batching plant of class A-1 as per BS : 6717-2001. The C.C. interlocking paving blocks be laid on average 25 mm thick bed of coarse sand and the joint is to be filled with fine sand. Laying procedure on compacted sub base as defined. Complete job is to be executed as per the instructions of Engineer-in-charge. The rates to be inclusive of all lead, lift, lifts & taxes general specifications of blocks.1. Shape : As specified by Engineer-in-charge.2. Tensile splitting strength and breaking load as per BS : 6717-2001 3. Colour : Grey cement natural colour 4. Variation in Dimension : Less than 1.6mm. 5. Variation in thickness : Less than 3.2mm b) 80mm thick

Cleaning of the existing black topped surfaces with brooms/soft brushes finally dusting with old gunny bags and compressed air to receive bitumious treatment [MoRTH Specification 501 to 503,112]

Add extra to item No. 6.2 for additional 0.1Kg per Sqm emulsion

Raised Pavment Marker ( Cats Eyes): Supplying and Fixing of Molded Shank Raised Pavement Markers made of polycarbonate and ABS moulded body and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face and shall support a load of 16000 kg tested in accordance to ASTM D 4280 Type H and complying to Specifications of Category A of MORTH Circular No RW/NH/33023/10-97 – DO III Dt 11.06. 1997. The height, width and length shall not exceed 50 mm, 100 mm and 100 mm and with minimum reflective area of 13 Sqcm on each side and the slope to the base shall be 35 +/- 5 degree. The strength of detachment of the integrated cylindrical shanks, (of diameter not less than 19 +/- 2 mm and height not less than 30+/- 2 mm) from the body is to be a minimum value of 700 Kgf. Fixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive as per manufacturer’s recommendation and complete as directed by the engineer. The contractor shall submit 2 years pre qualified warranty certificate from the manufacturer for satisfactory field performance during the time of bid submission

Providing and laying of hot applied thermoplastic compound inclusive type I reflectrosing glass beads as per table 800-3, 800-4 applied in uniform thickness of at least 2.5 mm and spread uniformly with reflectorising glass beads type II in addition @ 250 gms per Sqm with a road marking machine as per IRC: 35 complete with traffic diversion arrangement as per MORTH specification clause 803.4.

Plain/reinforced cement concrete in substructure complete as per drawing and technical specifications MoRTH Section 1500,1700, 2200.PCC Grade M-25.Height upto 5.00m.

Remove and Re-fixing of existing Precast concrete interlocking blocks laid on average 25 mm thick bed of river sand and the joint is to be filled with fine sand and Laying on R- prepared compacted sub base of existing base material. Complete job is to be executed as per the instructions of Engineer-in-charge. The rates to be inclusive of all lead, lifts & taxes. General specifications of blocks As specified by Engineer-in-charge.It incluse cost of river sand.