Water Resources Department Tender

Providing and Laying plain cement concrete M-15 in open foundation including supply, carriage, loading and unloading of material from an approved quarry complete as per drawing and technical specifications

Bored cast-in-situ M35 grade R.C.C. Pile excluding Reinforcement complete as per Drawing and Technical Specifications and removal of excavated earth with all lifts and lead upto 1000 m.

Levelling Course for Pile cap Providing and laying of PCC M15 levelling course 100mm thick below the pile cap.

Painting two coats including primer coat after filling the surface with synthetic enamel paint in all shades on new, plastered / concrete surfaces as per drawing and Technical Specification Clause 1701

Providing and laying RCC M-30 in open foundation with batching plant, transit mixer and concrete pump including supply, carriage, loading and unloading of material from an approved quarry complete as per drawing and technical specifications

Providing and laying RCC M-25 in open foundation with batching plant, transit mixer and concrete pump including supply, carriage, loading and unloading of material from an approved quarry complete as per drawing and technical specifications

Providing and laying Reinforced cement concrete M-30 in sub structure height up to 5 m using batching plant, transit mixer and concrete pump including supply, carriage, loading and unloading of material from an approved quarry complete as per drawing and technical specifications.

Furnishing and placing RCC Grade M-30 using batching plant, transit mixer and concrete pump for solid slab super structure including centering and shuttering height upto 5 m including supply, carriage, loading and unloading of material from an approved querry complete as per drawing and technical specification.

Furnishing and placing RCC Grade M-40 using batching plant, transit mixer and concrete pump for solid slab super structure including centering and shuttering height upto 5 m including supply, carriage, loading and unloading of material from an approved querry complete as per drawing and technical specification.

Provision of an Reinforced cement concrete crash barrier at the edges of the Bridge, road, approaches to bridge structures and medians, constructed with M-40 grade concrete, with HYSD reinforcement conforming to IRC:21 and dowel bars 25 mm dia, 450 mm long at expansion joints filled with pre-moulded asphalt filler board, keyed to the structure on which it is built and installed as per design given in the enclosure to MOST circular No. RW/NH-33022/1/94-DO III dated 24 Juner 1994 as per dimensions in the approved drawing and at locations directed by the Engineer, all as specified-with concrete mixture.

Providing and laying reinforced cement concrete M-25 in sub structure height upto 5 m using batching plant, transit mixer and concrete pump including supply, carriage, loading and unloading off material from an approved quarry complete as per drawing and technical specification

Cold twisted detormed (Ribbed/ Tor steel) Bars (Fe 500 grade as per IS 1786-2008) , for R.C.C works, where not including in the complete rate of RCC including bending and binding placing in position complete

Providing and laying jointing, fixing, testing ISI marked G.I Pipe (as per IS 1239) B class including cost of specials such as tees, bends, sockets, elbows etc, cutting, threading and testing in trenches in the ground complete (100 mm i/d)

Providing and fixing in position gully traps fixed in cement concrete 1:4:8 complete with grating 150x150mm, cover and frame clear opening 300x300 mm and outer size 330x330 mm and chamber including cost of all brick work etc.

Providing and filling expansion joint with sealing compound as per drawings and technical specifications with coarse sand and 6m percent bitumen by weight 10mm depth.

Providing and fixing in position 20 mm thick premoulded joint filler in expansion joint for fixed ends of simply supported spans not exceeding 10 m to cater for a horizontal movement 2mm covered with sealant complete as per drawing and specifications

Providing and Filling stone or spalls into crates and hand picking including supply of boulder stone and carriage approved from quarry, loading and unloading in all respect stacking and rehandling with avg lead 1 KM & extra loading and unloading manually.

Compaction of earthwork in 20 cm layers, dressing, watering, rolling of earth as per PWD specifications in all respect.

Removal/ Clerance of slush from wet drain by mechnical means

Disposal of slush lead upto 2 km using tippers

Providing weep holes in Reinforced cement concrete abutment, return wall with 100 mm dia PVC pipe through the full width of the structure with slope of 1V:20H towards drawing face complete as per drawing and technical specifications

Drainage spouts complete as per drawing no SD/205 and technical specification with 0.5 meter long GI 100 mm dia drainage GI light grade pipe (for Bridges)

Weaving of MSA wire crates netting 15cm x 15cm mesh i/c binding sides and partitions including supply of MSA wire 4mm dia as per PWD specifications.

Providing and laying of filter media with granular material/stone crushed aggregates satisfying the requirement laid down in clause 2504.2.2 of MORTH specification to a thickness of not less than 600 mm with smaller size towards the soil and bigger size towards the wall and provided over the entire surface behind abutment to the full height compacted to a firm conditions including supply and carriage of materials from approved quarry complete as per drawing and technical specifications.

Hazard marker sign board 300*900 mm rectangular as per IRC 67-2012 with high intensity micro prismatic grade retro reflective sheeting as per ASTM D 4965 09 and IRC 67 2012, fixed over 4mm thick aluminum composite material (ACM) sheeting having skin thickness of 0.4 to 0.5 mm on both sided and fixing the same with suitable size aluminium alloy rivets @ 200mm c/c to back support frame of 25*25*3mm angle iron supported on a square hollow steel section post 60*60*3.2mm conforminh to IS 4923 firmly fixed to ground including foundation, concrete M-25 of size 0.45*0.45*0.60m for verticle post complete as per clause 801 of MORTH specifications

Cautionary sign board 900x900x900mm triangular Using high intensity Microprismatic grade retro reflective Sheeting as per ASTM D 4956 09 and as per IRC 67 2012 with high intensity Microprismatic grade retro reflective Sheeting as per ASTM D 4956 – 09 and as per IRC 67 – 2012. fixed over 4mm thick aluminium Composite material (ACM) sheeting having aluminium skin thickness of 0.42to 0.5 mm on both sided and fixing the same with suitable size aluminium alloy rivets @ 200 mm c/c to back support frame of 25x25x3mm angle iron supported on a square hollow steel section post 60x60x3.2mm conforming to IS 4923 without cost of definition plate firmly fixed to ground in foundation concrete M-25 of size 0.45x0.45x0.60m for vertical post complete as per clause 801 of MORT&H specifications. Supplier shall provide a warranty as per clause 6.9 of IRC 67-2012 for retro reflective sheeting & a certified copy of test reports from an independent test laboratory conforming to clause 6.7 of IRC 67-2012 .

Providing, lowering in trenches to correct gradient and alignment, jointing with tyton rubber joint and cutting of reinforced cement concrete spigot and socketed pipes and specials with rubber ring ISI marekd as per IS code IS 458-2003 into trenches for all depths and laying out the same to correct alignment, gradients, levels etc. cutting of concrete beds and joints holes, supporting the pipes and specials in correct position in a suitable rigid manner while the same are being jointed and until the surrounding benchings, haunches and envelopes are completed. The pipes shall rest on the beds at all joints through their lengths and fixing of rubber ring, facing, testing the pipes for leakage and making good the same leakage and all defects to the entire satisfaction of the Engineer-in-charge including all cartage etc (RCC NP2 1200 mm i/d pipe).

Dismantling of brick work in cement sand mortar / lime mortar including T&P scaffolding wherever necessary, sorting the dismantled material, disposal of unserviceable material. & staking the serviceable material with all lifts & lead of 100 metre (By Mechanical Means)

Dismantling of pre-stressed/RCC including T&P scaffolding wherever necessary, sorting the dismantled material, disposal of unserviceable material. & staking the serviceable material with all lifts & lead of 100 metre (By Mechanical Means)

Painting two coats including primer coat after filling the surface with synthetic enamel paint in all shades on new, plastered / concrete surfaces as per drawing and Technical Specification Clause 1701

Removing Hume pipes from existing bridge

Any Other item