Punjab State Power Corporation Limited Tender

Centring and shuttering for flat surfaces such as suspended floors, roofs, landings, chajjas, shelves etc. CSR Item No. 9.8

Cement Concrete 1:6:12 with 40mm gauge stone aggregate. CSR Item No. 10.8-b(ii)

Reinforced cement concrete M-20 mechanically batch mixed using batch type concrete mixer as per IS:1791 and vibrated by needle vibrator but excluding steel reinforcement centring and shuttering in foundation and plinth. CSR Item No.10.15 As per AC slip no. 1

Damp proof course 4 cm thick of cement concrete 1: 2: 4 with two coats of bitumen 20/30 penetration at 1.65 kg per sqm laid hot and sanded. CSR Item No. 10.26

1st class burnt brick work in cement sand mortar 1:6 in foundation & plinth CSR Item No. 11.3(i)

1st class burnt brick work in cement sand mortar 1:4 in first storey upto 4 metres above plinth level CSR Item No. 11.8

Terracing consisting of tiles 22.86 x 11.43 x 3.83cm laid over 25 mm mud plaster 7.5 cm mud filling on another layer of 25mm mud plaster including two coats of bitumen laid hot at 1.65 Kg/sqm top of RCC slab including grouting with cement sand mortar 1:4 and top surface to be left clean after wire brushing CSR Item No. 13.13 i

Providing and fixing cast iron 100mm diameter rain water pipe with screw and wooden plugs fixed and wall-face including filling joints with spun yarn and cement mortar 1:2 excluding head and shoes etc. CSR Item No. 13.41

Providing and fixing cast iron head and shoe for rain water pipe on wooden plugs fixed on wall face including filling the joints with spun yarn and cement mortar 1:2. CSR Item No. 13.42 & 13.43

Top khurra 0.6m x 0.6m for rain water pipe in 25mm thick cement concrete 1:2:4 over 50mm thick cement concrete 1:8:16. CSR Item No. 13.45

Conglomerate floor 40mm thick cement concrete 1:2:4 on100 mm thick 1:8:16 concrete and 100 mm sand filling. CSR Item No. 14.9 & AC Slip no. 1

20mm thick grey polished skirting or dado consisting of bottom layer of 16mm thick cement sand plaster 1:3 and finished 3mm thick topping of neat cement rubbed and polished including rounding of junction with floor. CSR Item No. 14.16

12.5mm thick cement plaster 1:5. CSR Item No. 15.10

20 mm thick cement plaster in damp proof course 1:3 with two coats of bitumen at 1.65Kg. Per sqm laid hot and sanded a) Vertical CSR Item No. 15.50-a

White washing two coats. CSR Item No. 16.2

Finishing walls with exterior decorative cement based water soluble exterior paint such as snowcem robbiacem etc. two coats to give an even shade. CSR Item No. 16.13 & AC Slip 1

Kiln seasoned Hollock wood door shutters with 12 mm thick phenol bonded BWP ply ISI marked ply complete fixed in position single leaf 35mm thick CSR Item No. 17.10(xviii)-a-ii

Wire gauge Hollock wood door shutter without springs housed in chowkhat a) 35mm thick. CSR Item No. 17.11-ii(A)

Mild steel reinforcement for RCC work where not included in the complete rate of RCC including bending, binding and placing in position complete in all respects.(i) Up to 20mm diameter bars. CSR Item No.18.16(i)

Supply & fixing of pressed steel frames (Chowkats) consisting of 18 gauge (1.25mm) thick steel sheet of the specified section including iron lugs, iron hinges conforming to PWD specification including bolts for fixing stops, locknotch provision for receiving tower bolts, Hydraulic spring & finished with one priming coat of approved quality, fixed in position, including the cost of cement concrete 1:3:6 for filling the frame & cement concrete 1:2:4 for lugs complete. CSR Item No. 18.24-b b) Doors & window frame of size 113mm X 60mm with 35mm wide single rebate weighing 3.38 kg per meter.

Boring hand-pump in soil with admixture of shingle. CSR Item No. 26.7-B-ii B)Above 75mm dia. but not exceeding 100mm dia. Bores ii) Exceeding 15 m but upto 30 m.

Providing and laying, jointing fixing & testing ISI Marked GI pipe(as per IS 1239) B-class including cost of specials such as tees, bends, sockets, elbows etc. cutting threading and testing in trenches in the ground complete. CSR Item 28.36-a&c (A&C No.4) a) 15mm i/d

Providing and laying, jointing fixing & testing ISI Marked GI pipe(as per IS 1239) B-class including cost of specials such as tees, bends, sockets, elbows etc. cutting threading and testing in trenches in the ground complete. CSR Item 28.36-a&c (A&C No.4) a) 25 mm i/d

Providing ,fixing and jointing union coupling in GI pipe CSR Item No. 28.40-a & c a) 15mm i/d G.I. union

Providing ,fixing and jointing union coupling in GI pipe CSR Item No. 28.40-a & c a) 25 mm i/d G.I. union

Providing & Fixing in position 15 mm i/d bib cock of approved make (to the approval of Engineer-in-charge) complete in all respect. Brass Bib cock/Stop cock 15mm x. 400gm. CSR item No. 30.65 A (iv)

Providing & Fixing in position 15 mm i/d bib cock of approved make (to the approval of Engineer-in-charge) complete in all respect.C.P. brass Bib cock self-closing(iii) CSR item No. 30.65 B

Making soak pit 2.5 m Dia. 3.0 m deep with 45 x 45 cm dry brick honey comb shaft with bricks of class designation 75 and S.W. drain pipe 100 mm diametre, 1.8 m long complete as per standard design. CSR Item No. 29.48A. With F.P.S. bricks.

Providing and fixing in position china ware European type water closet P trap or Strap suit consisting of 10 lts PVC flushing cistern supported on angle iron bracket short bend 32mm diameter including cost of solid white cover complete in all respects and to the entire satisfaction of engineer in charge. CSR Item No. 30.10b

Providing and fixing jet spray with 2’-6” long PVC pipe CSR Item No. 30.8-a. a) With CP Brass nut.

Providing and fixing in position best Indian make white ordinary lavatory suit consisting 0f CP brass waste 32mm dia, pair of angle iron bracket with one CP brass tap complete. i) Size 450mmx300mm. CSR Item No. 30.32-i

Providing and fixing in position C.P brass Single Lever basin mixer without Popup waste with 450 mm Long Braided Hoses approved make (to the approval of Engineer in-charge) complete in all respect. CSR Item No. 30.39.

Providing and fixing in position C.P. brass soap dish of approved make (to the approval of Engineer-in-charge ) fixed into wall with rawl plugs and C.P brass screws complete in all respect. CSR Item No. 30.60

Providing and fixing in position best Indian make beveled edge 5mm thick mirror mounted on 4mm thick Cardboard sheet ground fixed in position by means of 4 nos. chromium plated brass screws and washers over rubber washers and rawl plugs embedded in the walls or chromium plated brass clamps with C.P. brass screws (as required by the Engineer-in- Charge) complete including cutting & making good the walls etc. CSR Item No. 30.61-b. b) Size 550mmx400mm

Providing and fixing in position 15mm i/d bib cock of best quality (as approved by the Engineer-in-charge). CSR Item No. 30.65-A(v). V) Brass Nozel Bib cock 15mm x

Providing & fixing in position stop cock/Angle valve (as approved by the Engineer-incharge). CSR Item No.30.66-a (a) C.P.brass 15mm stop cock Male and female end

Providing and fixing in position SWR UPVC soil waste vent or antisyphonage pipes as per IS -13592 including cutting, jointing, wastage, but excluding cost of lead jointing. CSR Item No. 30.74-iii-A-d A. Double socket A Type d) 75mm i/d SWR UPVC pipe lines laid complete

Providing and fixing in position SWR UPVC special for soil waste vent or anti syphonage pipes as per as per IS - 14735 including cutting and wastage etc. cutting holes in walls roofs or floors etc. and making good to its original condition but excluding cost of lead joining. CSR Item No. 30.81-iii-D-v B) For 75mm i/d pipes v) 75mm i/d Bend plain

Providing and fixing in position automatic bras ball valve in water tank CSR Item No. 30.96-B-i a) 15mm i/d Brass ball valve with copper ball

Providing and fixing in position PVC water storage tank triple layer make as approve by Engineer-In-Charge including hoisting and carriage from store to site of work with complete providing and fixing 20mm i/d tanki nipple excluding cost of platform CSR Item No. 30.97-a a) Tanks upto 1000 ltr. Capacity

RECESSED HDPE PIPE WIRING SYSTEM WITH FLUSH PIANO TYPE SWITCHES. Wiring in PVC insulated copper conductor single core FRLS able (ISI marked), 1100volts grade to be laid in HDPE conduit pipe 20mm/25mm dia. ISI Marked, recessed in wall etc., complete with powder coated/anodized concealed metal boxes required for having electronic fan regulators, bell push, electronic buzzer, 3pin 6Amp., 3pin 16/20 Amp. Sockets and 6 Amp./16/ 20Amp. Switches (flush piano type accessories) etc. and covered with brown Bakelite white glazed translucent backside painted sheet 3mm thick etc., & including the cost of flush piano type switches/sockets, step type electronic fan regulator 100 watts, PVC connector (For Fan Box and Electronic Buzzer), PVC Bush, Steel Hooks, Cast Iron circular Inspection box (Recessed Type and Deep Type) HDPE electrical conduit pipe & copper wire and other petty material etc. including the cost of cutting and filling up of chases:- ii) Wiring light point in PVC insulated copper conductor single core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade. CSR Item No. 34.06-b-ii & AC Slip-3 iv) Wiring 3 pin 6 Amp. wall socket (Shuttered) point in PVC insulated copper conductor single core FRLS cable (ISI marked) overall 1.5 sq. mm, 1100volts grade complete with bonding to existing earth with PVC insulated copper conductor single core FRLS cable (ISI marked) overall 1 sq. mm, 1100volts grade. CSR Item No. 34.06-iv & AC Slip-3

Wiring 3 pin 16/20 Amp power plug control (shuttered) and switch. CSR Item No.34.06 -B-(vi)

PVC INSULATED SINGLE CORE FRLS COPPER CONDUCTOR CABLE Supply and erection of PVC insulated single core FRLS copper conductor cable ISI marked left bare in pipe or casing of suitable size excluding the cost of supply and erection of pipe or casing. (iv) PVC insulated copper conductor single core FRLS cable (ISI marked) overall 4 sq.mm, 1100volts grade. CSR Item No. 34.09-iv

PVC, HDPE PIPES & PVC FLEXIBLE PIPES: Supply & erection of PVC pipes & HDPE pipes (fire retardant) for wiring purposes including bends, inspection boxes etc., where necessary including other petty material as per PWD General Specifications 2010:- ii) Heavy gauge PVC conduit pipe 25mm dia. (ISI marked 2mm thick) On Surface. CSR Item No. 34.12-ii

A SWITCH DISCONNECTOR FUSE UNIT (Without Sheet encloser): Supply and erection of Switch Disconnector fuse unit with HRC Fuses (Panel mounting Cubicle type) in the existing Cubical Panel (conforms to IS 13947 (Part I & III) complete with G.I. Bolts, Nuts & Connection on both sides of switch with suitable size of Thimbles, including cost of HRC fuses as per PWD General Specifications 2010. i) 32Amp. 415volts three pole & neutral switch disconnector fuse unit with HRC Fuses. CSR Item No. 34.21-A-i

Providing and installing in position of domestic water pressure boosting pump of approved make (To the approval of Engineer in-charge) including all pump accessories but excluding cost of G.I. pipe & specials complete in all respects. As per CSR 28.104 A (c) Pressure pump of 1.0 HP with 3300 LPH, 50meter head with CI pump & 19 litre capacity tank

Submersible Pump (1.0HP) with all accessories(Submersible cable, stater etc.) of Kirloskar or equivalent make (Non CSR Item)