Jawaharlal Institute Of Postgraduate Medical Education And Research Tender
View complete overview of Puducherry JIPMER Tender
Jawaharlal Institute Of Postgraduate Medical Education And Research - JIPMER Tender
Civil And Construction
Solid Waste Management
Consultancy Services
Civil And Architectural Services
Eprocure
Opening Date13 Nov 2024
Closing Date27 Nov 2024
Tender AmountRefer Documents
Costs
EMD
₹ 1,59,000Document Cost
₹ 590Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2024_JIPMP_834657_1Tender No
ED/WORKS/OCT /2024/3Tender Authority
Jawaharlal Institute Of Postgraduate Medical Education And Research ViewPurchaser Address
-Website
http://https://www.jipmer.edu.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
Anaerobic digester- Type – anaerobic Digester Made of RCC with fiber reinforced plastic coating 450 emulation glass matt and isopathallic resin and gel coat an inlet for feed, outlet for slurry collection.
-
-
-
Water sealing- Supply & erection of water sealing UV resistant seven-layer 3mm thickness FRP segments made up of fiber reinforced plastic of three layers 450 emulation glass matt and isopathallic resin and gel coat segments molded in fiber reinforced plastic mould with ribs for strengthening around gas holder Mild Steel structure inside to support and strengthening the water sealing
-
-
-
Gas holder - FRP Gas holder UV resistant seven-layer 3mm thickness FRP segments made up of fiber reinforced plastic of three layers 450 emulation glass matt and isopathallic resin and gel coat segments molded in fiber reinforced plastic mould with ribs for strengthening around gas holder Mild Steel structure inside to support and strengthening the gas holder as per digester measurement
-
-
-
Hydraulic agitator for digester- Agitator is fixed at the bottom of digester the biogas plant at its side to make sure that the feed is completely mixed to increase the bacterial growth.
Avoids scum formation
Increases the biogas yield up to 15%
Improves bacterial growth
Ensures proper mixing
-
-
-
Inlet and outlet screw - product series as helical in-line gearboxes
frame size 25 - MN2=200NM/TN2=1770 LBIN
version p – flang mount gear ratio 25.75
input configuration 090 - IEC 90 input
motor mounting b5
mounting position b3
power : 2 hp - 3 phase 1440 rpm
semi-automatic
voltage – 220-240 v
bottom supporting with steel ball 9inches(inner dia) cement pipe for inletand outlet
-
-
-
Slurry tank with cover- Slurry tank with cover UV resistant Three-layer 3mm thickness FRP segments made up of fiber reinforced plastic of three layers 450 emulation glass matt and isopathallic resin and gel coat segments molded in fiber reinforced plastic mould with ribs for strengthening around
slurry tank
-
-
-
H2S scrubber- Supply of FRP H2S scrubber – Fe2 media and scrubber etc
Bio gas line size : 2” for inlet & outlet and ½” for water discharge
Space required : 2 ft (D) x
5 ft (H)
-
-
-
Moisture filter- Supply of moisture filter one inch filter with working pressure up to 16
bar imported s.s cartridge
-
-
-
Flow meter- Flow meter 20 cubic meter per hour biogas flow meter 10 Kpa/0.1 bar / 1.45 psl maximum pressure reading 2m3/Hr maximum flow rate IP 65 rated ABS (flame retardant) enclosure 170 x 117 x 44 mm
enclosure size
-
-
-
Electrical & plumbing- Electrical incoming : 63 A 4P on load change over switch RYB phaseindicators 75A rating aluminum TPN bus bar 3 HP direct online starter 10A Tp MCB 1 set 18A
Tp power contactor 4.5 – 7.5A range over load relay 10 Sqmm outgoing clip on connector 2.5 Sqmm copper power wiring Illumination type on-off push button 2 Hp direct online starter 10A Tp MCB 1 set 12A Tp power contactor 3-5A range over load relay 10 Sqmm outgoing clip on connector 2.5 Sqmm copper power wiring Illumination type on-off push button Make : CHO SWITCH + CONTACTOR+ OLR + MCB’S are L&T make Panel made: wall mounted 1.6mm thick tata cr sheet powder coat finish.
-
-
-
Initial feeding - Initial inoculant feeding of cow dunk slurry with innoculants & enzymes etc complete as per standard
specification
-
-
-
Slurry pump- Sludge pump submersible sludge pump 2.0 Hp, three phase etc complete as per
standard specification
-
-
-
Providing and fixing G.I. chain link fabric fencing of required width in mesh size 50x50 mm including strengthening with 2 mm dia wire or nuts, bolts and washers as required complete as per the direction of
Engineer-in-charge. Made of G.I. wire of dia. 4 mm, PVC coated to achieve outer dia not less than 5 mm in required colour and shade
-
-
-
Providing and laying 60 mm thick faciory made cement concrete interlocking paver block of M -30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of coarse sand, filling the joints with line sand etc. all complete as per the direction of Engineer-in-charge. (SQM.)
-
-
-
CEMENT CONCRET (CAST IN SITU) Providing and laying in position cement concrete of specified grade excludingthe cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 5 coarse sand (zone-III): 10 graded stone aggregate 40 mm nominal size).
-
-
-
Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat with Enamel Paint of approved steel primer all complete.
-
-
-
15 mm cement plaster on rough side of single or half brick wallof mix:(including scaffolding upto 5metre height)- 1:4 (1 cement: 4 coarse sand) (including scaffolding)
-
-
-
Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:6 (1 cement : 6 coarse sand)
-
-
-
Finishing walls with Acrylic Smooth exterior paint of required shade : New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm)
-
-
-
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements
Past BiddersThis list is curated from the bidders of the similar tenders in the past
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%
- Bidder NameThis Information is for unsubscribed user This Information is for unsubscribed user
- Awarded Ratexx%