Department Of Local Administration Tender

Code No. 4.1.10 Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all workupto plinth level - 1:5:10 (1 cement : 5 fine aggregate : 10 graded stone aggregate 40mm nominal size)

Code No. 4.3.1 Centring and shuttering including strutting , propping etc. and removal of form work for - foundations, footings, bases for columns

Code No. 10.25.1 Steel work welded in built up sections / framed work , including cutting,hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required - in stringers, treads, landings etc. of stair cases, including use of chequered plate wherever required all complete.

Code No. 13.16.1 6mm cement plaster of mix 1:3 (1 cement : 3 fine aggregate)

Code No. 15.2.1 Demolishing cement concrete manually / by mechanical means including disposal of material within 50 metres lead as per direction of Engineer-in-charge. - Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

Code No. 4.1A.1 Construction of granular sub-base by providing close graded material, mixing in a mechanical mix plant at OMC, carriage of mixed material to work site, spreading in uniform layer with motor grader on prepared surface and compacting with vibratory power roller to achieve the desired density, complete as per clause 401of MoRTH specification,, 4th Revision by plant mix method for grading I material

Code No. 4.92C Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth 3 wheeld steel roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite Crushable type such as moorum or gravel for screening and gravel for binding to fill up the interstices of coarse aggregate, watering and compacting to the required density - by manual means -Water bound macadam Gr-II with moorum or gravel screening. (As per MoRTH specification, 4th Revision)

Code No. 0322 Hire charges for front end loader (JCB) as directed by the Engineer-in-charge.

NPSR (SE approved rate : No.523/SE-OM/AE(P)/LAD/2016-17, dt.08/03/2017) Fabrication, supply and fixing of Village / informatory name board of size 1.06mts x 0.61mts. The width of the board is tapered at 0.80mts upto 1.06mts to give the triangular shape at One end with High Intensity reflective sheeting of required color encapsulation on aluminum sheet of not less than 2mm thick suitably supported and framed with 25mm x 25mm x 3mm AISI 316 grade Stainless steel angle and the board frame is supported alround with AISI 316 grade stainless steel pipe of 38.10mm dia (outer dia & 2mm wall thickness). The Village names / street names, lettering and symbols will be provided by High Intensity grade white sheeting. The board is supported by Two Nos. of 63.5mm dia post S.S. pipes of 2.0mts. height with same dia Dummy plate arrangement at the top. The board frame and post pipes are welded by Tig welding with necessary polishing etc. and M.S. pipe of 50mm dia for a length of 35cm will be welded at the bottom of the posts and fixed in a ground pit of size 0.45 x 0.45 x 0.50 mts. with P.C.C 1:2:4. Rate including all the materials, S.S. welding, Grinding, Polishing, fabrication charges, Conveyance etc. except Earth work and PCC charges, complete.