Works Department Tender

Construction of Un-Reinforced, Plain Cement Concrete Pavement, thickness as per design, over a prepared sub-base, with 43 grade cement or any other type as per Clause 1501.2.2, M30 (grade) coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25mm mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars near approaches to bridges and culverts (expansion joints), admixtures as approved, curing of concrete slabs for 14 days, curing compound and water finishing to lines and grade as per drawing and Technical Specification Clause 1501.

Providing Rainforced Cement Concrete of (1:2.5:5) with 20mm to 40mm size stone aggregate in foundations upto a depth of 1.5m below ground level and upto a height of 1.5m above ground level / bed level including cost and conveyance of all materials to site, and all labour charges complete as per direction of E.I.C.

200 Mtr stone

Guard Post

Construction of Earthern shoulder with approved materials obtained from borrow pits, transporting to site, spreading, grading to required slope and compacting to meet requirement as per MORD technical Specification Clause 303 with all leads & lift as per direction of the Engineer in charge (By mechanical means).

Periodic Renewal

Providing and apppying primer coat with bitumen Emulsion using emulsion pressure distributer at the rate of 0.20kg per sqm on the prepared bituminous/granular surface etc complete

Providing and apppying tack coat with bitumen Emulsion using emulsion pressure distributer at the rate of 0.30kg per sqm on the prepared bituminous/granular surface etc complete

Providing and laying semi dense bituminous concrete with batch type hot mix plant using crushed aggregates of specified grading, premixed with bituminous binder of 60/70 penetration grade of bitumen, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheelede, vibratory and tandem rollers to achieve the desired compaction as per Clause 508 of MoSRT&H Specifications for Road & Bridge works (4th Revision)

Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The finished surface to be level, uniform and free from streaks and holes.

Providing and fixing of semi reflective cautionary, mandatory and informatory sign board as per IRC:67 made of 1.5 mm thick MS Sheet duly stove white colour in front and gray colour on back with red reflective border of 65 mm width and required letters and figures with reflective tape engineering grade as per Clause 1701.3.9 of MORD for Rural Roads of required shade and colour supported and welded on 47mm x 47 mm x 12 SWG sheet tube firmly fixed to the ground by mean of properly designed foundations with M-15 grade cement concrete 450x450x600 mm, 600 mm below ground level as per approved drawing Clause 300,800,1700 as per direction of the Engineer in charge.(600 mm square)

Providing and fixing of typical PMGSY citizen information board as per MORD specifications and drawing. Three MS Plates of 50x5mm mm thick, back plate duly welded with 75mm dia steel tubes back on edges as per drawings. The upper & lower plate will be welded with MS flat iron frame of 50mmx5mm. The steel tubes duly embedded in cement concrete M-15 grade blocks of 600mm x 600mm x 750mm below ground level.All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and Annexture 1700.1.

Emergency works (Work to be taken up as per the reqirement & separate work order to be issued by PIU)

Routine Maintenance including all taxes.

Routine Maintenance

BT works

For 1st Year

For 2nd Year

For 3rd Year

For 4th Year

For 5th Year

CC works

For 1st Year

For 2nd Year

For 3rd Year

For 4th Year

For 5th Year