Works Department Tender

Providing plain cement concrete M-10 (1:3:6) mix with 40mm nominal size stone aggregate in open foundation upto a depth of 1.5m. Below ground level & upto a hight of 1.5m. Above ground level/bed level including cost & conveyance of all materials to site & all labour charges complete as per specification clause 802, 803, 1202 & 1203 and direction of the Engineer - in - charge.

Plain/reinforced cement concrete in sub-structure complete as per drawings and MORD technical specification Clauses 800,1200 and as per direction of the Engineer in charge (PCC grade M 15 ( Nominal Mix 1:2.5:5)

Rough Stone Dry Packing in approns and Revetment with hard Granite Stones including watering curing cost conveyance royalty etc complete asper direction of Engineer in charge.

Providing weepholes in brick masonry/stone masonry, plain/reinforced concrete abutment, wing wall, return wall with 100 mm dia AC pipe extending through the full width of the structures with slope of 1(V):20(H) towards drawing face complete as per drawing and technical specification as per section 600,700,&1200 of MoRD

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Earth work in all kinds of soil with 50m initial lead and 1.5m initial lift including rough dressing and breaking clods to maximum 5cm to 7cm and laying in layers not exceeding 0.3m in depth and compaction with PRR including hire and running charges of PRR etc. complete as per specification and direction of the Engineer-in-charge.

Reinforced cement concrete M15 grade Guard stone/local stone of standard design as per IRC:25 fixed position including finishing as per drawing and Technical specification Clause of MORD etc.complete as per direction of the Engineer-in-charge.

Paintin two coats including prime coat with epoxy paint of approved brand on concrete/steel surfaces after through cleaning of surface to give an even shade as per drawing and Technical Specification Clause 1701 of MORD.

Providing and fixing of semi reflective cautionary, mandatory and informatory sign board as per IRC:67 made of 1.5 mm thick MS Sheet duly stove white colour in front and gray colour on back with red reflective border of 65 mm width and required letters and figures with reflective tape engineering grade as per Clause 1701.3.9 of MORD for Rural Roads of required shade and colour supported and welded on 47mm x 47 mm x 12 SWG sheet tube firmly fixed to the ground by mean of properly designed foundations with M-15 grade cement concrete 450x450x600 mm, 600 mm below ground level as per approved drawing Clause 1701.2.2

800 mm x 600 mm Rectrangle

600MM EQILATERAL & TRIANGLE