Works Department Tender

Providing and applying Tack Coat with 60/70 penetration grade of bitumen using bitumen pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom as per Clause 503 of MoSRT&H Specifications for Road & Bridge works (4th Revision)

Providing and laying semi-dense bituminous concrete with 100-120 TPH batch type HMP producing and average 75 tone per Hour using crushed aggregate specified grading, premix bituminous binder @ 4.5 to 5 per cent of mix and Filler, transporting the hot mix to works site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheel, vibratory and tandem rollers to achieve the desire compaction as per MoRTH specification clause No. 508 data book page-135.

Construction of embankment with materials obtained from borrowpits with all lead spreading , grading to required slope and compacting to meet the required table 300-2 not exceeding 250 mm and compaction with plate compactor or power rammer to restore the original alignment, level and slopes as per drawings and MORD technical specifications Clause 1902 by manual means as per direction of the Engineer in charge

Earth work excavation in hard soil or gravelly soil within 50m initial lead and 1.5m initial lift including rough dressing and breaking clods to maximum 5cm to 7cm and laying in layers not exceeding 0.3m in depth and as per direction of the E-I-C.

Filling sand-Supplying & filling good clean river sand of approved quality including watering to complete saturation & ramming complete with all leads & lifts including cost, conveyance, royalty & taxes of all materials & cost of all labour & T&P required for the work etc. complete as per specification & direction of Engineer in charge.

P.C.C(1:3:6) using 40mm size H.G.metal well rammed with cost, Conveyance , royality,taxes of all material and labour,T & P etc.Complete.(AR-2006-P-43)Per one cum

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Supplying Fitting Fixing of 15 cm dia 1 mt long guard posts of RCC 1:2:4 using 3.5 kg of steel for each guard post with BHG chips including cost of all reinforcement material centering shuttering etc complete as per direction of the Engineer-in-charge