Rural Works Department Tender

Providing and laying 20 mm thick Premix Carpet using 0.18 cum of 13.2 mm and 0.09 cum of 11.2 mm size chips with 14.60 kg. penetration grade of bitumen per 10 sqm including hand packing to proper camber and rolling with PRR including hire and running charges of PRR, tar boiler and other T&P articles including all cost, carriage, royality of chips and bitumen etc

Providing and laying 6 mm thick precoated Seal Coat Type - B using 0.06 cum of 6.7 mm size chips and down graded as per sieve analysis and 6.8 kg. of bitumen per 10 sqm including hire and running charges of PRR, bitumen mixture, tar boiler etc including all cost, carriage, royality of chips and bitumen etc.

Construction of embankment with approved material obtained from borrow pit with all lift & leads, transporting to site by mechanical means within a lead of 5 Kms,spreading, grading to a required slope & compacting to meet requirement of table 300-2 & clause 305 of MoSRT & H specification for Road & Bridge work

Earth work in excavation in hard soil or gravelly soil within 50m. initial lead and 1.5m initial lift including rough dressing and breaking clods to maximum 5cm to 7cm and laying in layers not exceeding 0.3m in depth and as per the direction of the Engineer-in-charge

Supplying & filling good clean river sand of approved quality including watering to complete saturation & ramming complete with all leads & lifts including cost, conveyance, royalty & taxes of all materials & cost of all labour & T&P required for the work etc. complete as per specification & direction of Engineer in charge

P.C.C. (1:3:6) using 40mm size H.G. metal well rammed with cost, conveyance, royality, taxes of all material and labour, T & P etc. complete as per direction of Engineer-in-Charge.

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Supplying, fitting and placing uncoated HYSD bar reinforcement complete as per drawing and technical specification etc. complete as per direction of Engineer-in-Charge