Rural Development Department Tender

Filling sand-Supplying & filling good clean river sand of approved quality including watering to complete saturation & ramming complete with all leads & lifts including cost, conveyance, royalty & taxes of all materials & cost of all labour & T&P required for the work etc. complete as per specification & direction of Engineer in charge.

P.C.C(1:3:6) using 40mm size H.G.metal well rammed with cost, Conveyance , royality,taxes of all material and labour,T & P etc.Complete

Supplying,fitting and placing uncoated HYSD bar reinforcement complete as per drawing and technical specification.(AR,P-52)

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Supplying & Fixing of 80mm thick cement concrete interlocking paver block of M-40 grade of approved make design, colour and size made by Block making machine with proper compaction laid in required pattern etc. complete in all respect conforming to IRC SP-36:2018.

Providing 37.5 mm thick BUSG in one layers applying tack coat using 3.0 kg of bitumen /10 sqm, using 0.45 cum of 25mm to 40mm size H.G. metal & 0.12 cum of 12mm size h.g. chips for 10 sqm . etc. complete.

Providing & applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20kg per sqm on the prepared bituminous / granular surface cleaned with mechanical broom as per clause 503 of MOSRT&H Specifications for Road & Bridges work (4th Revision).

Providing,laying and rolling of opengraded premix surfacing of 20mm thickness composed of 13.2mm to 5.6mm aggregates with batch type hot mix plant and using 60/70 penetration grade and level to serve as wearing course on a previously prepared base including mixing in a suitable plant,laying and rolling with a smmoth wheeled roller 8-10 tonne capacity, finished to required level and grades as per clause 511 of MoSRT&H Specifications for Road & Bridge Works(4th Revision).

Providing and laying 6mm thick precoated seal coat Type-B using 0.06cum of 6.7mm size chips and 6.80kg of 60/70 penetration grade of bitumen for 10sqm with 100-120 TPH