Rural Development Department Tender

Dismantaling and removing cement concrete pavement by mechanical means using pneumatic tools, breaking to pieces not exceeding 0.02cum in volume and stock piling at designated location and disposal the debris upto a lead of 1000m lead all cost conveyance labour T & P require for the work etc. complete as per direction of the E.I.C.

Providing,supplying,fitting and fixing of 80mm thick interlocking concrete paver block on compacted river coarse sand free from all organic materials and filling the joints with sand including cutting,corbelling, splays whereever necessary to proper size with cost,conveyance,royalities of all materials and as direction of Engineer-in-charge.

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Providing R.C.C. M-25 with nominal size stone aggregate in foundations upto a depth of 1.5m below ground level and upto a height of 1.5m above ground level / bed level including cost and conveyance of all materials to site, and all labour charges complete as per direction of the Engineer-in-charge.

Supplying and straightening bent up or coiled rods cutting, bending, cranking, hooking, welding (if required) the M.S.Rods or Tor steel & binding and tying the grills, hoisting, lowering & placing in proper position as required for R.C.C. works with all cost, conveyance & taxes of M.S. rods or Tor steel & binding wires of 18 to 20 gauge & labour with all T&P required for the work etc. complete in all floors (weight of binding wires and laping of MS rod will not be considered for payment & payment will be made on weight of M.S.rods or Tor steel only).as per direction of the Engineer-in-charge.