Rural Development Department Tender

Providing applying tack coat with penetration grade of bitumen emulsion using bitumen pressure distributor @ 0.20 Kg /Sqm including all cost & conveyence complete as per the specification and direction of the Engineer-in-charge.

Providing applying tack coat with penetration grade of bitumen emulsion using bitumen pressure distributor @ 0.20 Kg /Sqm including all cost & conveyence complete as per the specification and direction of the Engineer-in-charge.

Providing & laying 20mm thick premix carpet using 0.23 cum of 13.20mm to 5.60mm size crushed stone chipping & 14.60Kg penetration grade of bitumen for 10sqm including hire & running charges of PRR , hot mix plant , bitmen boilers & all other T & P articles but excluding coat & conveyance of chips & bitumen complete as per specification & direction of the Engineer-in-charge.

Providing and laying 6mm thick precoated seal coat Type-B using 0.06 cum of 6.7mm size and down graded chips as per 10sqm including hire and running charges of PRR , hot mix plant, tar boiler and all other T & P articles including cost & conveyance of chips and bitumen etc.complete as per the specification and direction of the Engineer-in-charge.

Finishing wall with water proofing cement paints of approved shade on new work two coats to give even shade including cost of cement paint, all taxes, cess with all labour and T&P required for the work etc complete as per direction of the Engineer-in-charge.

Excavation for roadway in hard soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, inaccordance with requirements of lines, grades and cross sections, and transporting to the embankement location with a lift of up to 1.5m and lead up to 1000m as per techincal specification clause 302.3 of MoRD and as per direction of Engineer-In-Charge.

Providing & filling good clean river sand of approved quality including watering to complete saturation & ramming complete including cost conveyance, royalty, additional charges, DMF 10% & EMF 5% over royalty Cess & taxes of all materials & cost of all labour & T&P required for the work etc complete as per specification & direction of Engineer-in Charge.

Providing Plain Cement concrete M-15 in foundation upto a required depth below ground level and upto a required height above ground level/bed level using 40mm down graded hard granite aggregates of approved quality from approved quarry including hoisting, lowering, laying compacting in position in layers to proper slope & level including watering, curing and cost, conveyance, Cess, royality, additional charges, DMF 10% & EMF 5% over royalty taxes of all materials etc. with all labour and T&P required for the work including dewatering, shuttering if necessary complete as per direction of Engineer – in – charge

Construction of un-reinforced, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, primer, sealant, near approaches to bridge/culvert or at any approved portion of road and construction joints, admixtures as approved, curing of concrete slabs for 14-days as per MoRD including cost, conveyance, royality, additional charges, DMF 10% & EMF 5% over royalty Cess, taxes & technical specification Clause 1501 and as per direction of Engineer-in-Charge.