Rural Development Department Tender

Providing and applying primer coat with penetration grade of bitumen emulsion using bitumen presser distributer including cost and conveyance of all materials required with all labour and T and P etc complete in all respect as per direction of the Engineer in charge

Providing and labour applying tack coat with penetration grade of bitumen emolation including all cost, conveyance, taxes, royalities, with all labour and T&P etc. complete with all labour and T&P in all respect as per direction of the Engineer-in-charge. Granular base

Providing and laying semi dence bitumen carpet with 100-120 TPH hot mix plant producuing an average output of 75 tonnes per hour using crushed aggregates of specified grading premixed with bituminous binder transported to site laid over a previously prepared surface with paver finisher to the required grade level and alignment and rolled as per clause 507 to achieve the desired compaction including all cost, conveyance taxes royalities with all labour and T and P required for the work etc complete as per direction of the Engineer in charge

Reinforced cement concrete M 15 grade Kilometre stone of standard design as per IRC 8 fixing in position including painting and printing etc. with all cost, conveyance, taxes, royalities with all labour and T&P etc.complete in all respect as per direction of the Engineer-in-charge Ordinary Kilometre stone

200 mtr stone ( precast )

12mm thick cement plaster in cm l:6 for brick work including all cost conveyance taxes royalities Cess with all labour and T and P with proper watering and curing etc complete in all respect as per direction of the Engineer in charge

Painting two coats including prime coat with epoxy paint of approved brand on concrete/steel surfaces after through cleaning of surface to give an even shade as per drawing and Technical Specification Clause 1701 of MORD and as per direction of Engineer in charge.

Construction of embankment with approved materials obtained from borrow pit with all lift and lead transporting to site by mechanical means within a lead of 5km spreading, grading to a required slope and compacting to specification requirements as per the direction of Enigneer in charge

Providing & erecting direction & place identification retro reflectorised sign as per IRC-672012 made of class B retro reflective sheeting of high intensity and high intensity prisamatic grade sheeting as per ASTM D 4956-09 type III & IV strectly confirming to clause 6.7 of IRC 67-2012 and clause 801 3, fixed over aluminium sheeting 2.00mm thick as per clause 6.5.2 of IRC 67-2012 or ACP ( aluminium composite pannel used for sign boards with thermoplastic core of low density polyethylene ( LDPE ) between two thick sheets of aluminium with over all thickness of 4mm & aluminium thickness of 0.5mm on bothsides supported on mild steel angle post 75mmx75mmx6mm, 2 nos and three nos horizontal and 1 no verical extra supporting member of MS angle of size 50mmx50mmx6mm firmly fixed to the ground by means of properly designed foundation with M 15 grade cement concrete 45cmx45cmx75cm, 60 cm below ground level as per approved drawing including cost, conveyance royalities taxes of all materials and labour and T&P excavation & curing etc complete as per direction of the Engineer in charge

Providing & fixing of semi reflective cauktionary mandatory and informatory sign board s per IRC 67 made of 1.5mm thick MS sheet duly stove whie colour in front and gray colour on back with red reflective boarder of 65mm width and require letters & figures with reflective tape engineering grade as direction of the Engineer-in-chrge

I ) 600mm equilateral triangle

ii ) 600mm Circular

iii ) 600mmx600mm square