Odisha Hydro Power Corporation Limited Tender

24 mm thick factory made PVC door shutters made of styles and rails of a uPVC hollow section of size 59x24 mm and wall thickness 2 mm (± 0.2 mm) with inbuilt edging on both sides. The styles and rails mitred and joint at the corners by means of M.S. galvanised/ plastic brackets of size 75x220 mm having wall thickness 1.0 mm and stainless steel screws. The styles of the shutter reinforced by inserting galvanised M.S. tube of size 20x20 mm and 1 mm (± 0.1 mm) wall thickness. The lock rail made up of ‘H’ section, a uPVC hollow section of size 100x24 mm and 2 mm (± 0.2 mm) wall thickness, fixed to the shutter styles by means of plastic/galvanised M.S. ‘U’ cleats. The shutter frame filled with a uPVC multichambered single panel of size not less than 620 mm, having over all thickness of 20 mm and 1 mm (±0.1 mm) wall thickness. The panels filled vertically and tie bar at two places by inserting horizontally 6 mm galvanised M.S. rod and fastened with nuts and washers, PVC handle, Aldrop/ Tower bolt, etc. complete as per manufacturer’s specification and direction of Engineer-in-charge. (For W.C. and bathroom door shutter). Decorative Finish (Printed, white, grey or wooden finish)

Removing of cement plaster from walls including racking out joint to 12 mm deep and removing the debris away from work site with all leads and lifts as per direction of Engineer-in-charge.

First Class Fly Ash brick masonry in cement mortar (1:6) using Fly Ash brick having crushing strength not less than 75 Kg/Cm2 with dimensional tolerance of +/- 8% after immersing the bricks in water for six hours before using foundation and plinth including hoisting, placing in position, watering, curing to required time etc. including cost, converyance, royalties and taxes of all materials and cost of all labour with T & P required for the work etc. complete as per direction of Engineer-in-charge.

16 mm thick cement plaster (1:6) after racking out the joints including watering, curing to required time, cost, conveyance, royalties, taxes of all materials, cost of all labour with T & P required for the work complete as per direction of Engineer-in-charge.

White washing two coat with shell lime over the interior surface of walls and ceiling including cost, conveyance, taxes of all materials, cost of labour with T & P required for the work complete etc. as per direction of Engineer-in-charge.