Assam Rifles Tender

all as above item but 3 core 95Sqmm.

Laying of one number PVC insulated and PVC Sheathed/XLPE power Cable of 11KV grade of size up to 120 Sqmm direct in ground including excavation, sand cushioning, protective covering and GI pipes as per site requirement and refilling the trench etc as required.

Supply and fix cable jointing kit for 11 KV grade cable for in door termination, heat shrink type, joint complete with jointing material and accessories suitable for3 core XLPE, armoured, Al conductor cable of size 3 core 120 sqmm. Make : As per sample approval

Supply and fix cable jointing kit for 11 KV grade cable for outdoor termination , heat shrink type, joint complete with jointing material and accessories suitable for 3 core XLPE, armoured, Al conductor cable of size 3 core 120 sqmm Make : As per sample approval.

Supply and fix cable jointing kit for 11 KV grade cable for straight through cold shrink type joint complete with jointing material and accessories suitable for 3 core XLPE, armoured, Al conductor cable of size 120 to 185 sqmm, Indoor/Outdoor type. Make : As per sample approval

Earthing with copper earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required. Noted : Copper Earthing for VCB & RMU Only

Providing and fixing 25 mm X 5 mm copper strip in 40 mm dia G.I. pipe from earth electrode including connection with brass nut, bolt, spring, washer excavation and re-filling etc. as required.

Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

Supplying and laying 25 mm X 5 mm G.I strip at 0.50 metre below ground as strip earth electrode, including connection/ terminating with G.I. nut, bolt, spring, washer etc. as required. (Jointing shall be done by overlapping and with 2 sets of G.I. nut bolt & spring washer spaced at 50mm)

Supplying and fixing of light class G.I. pipe of 80 mm dia. (nominal) 3 metres length along the pole for protection of under ground cable as required.

Supplying and making cable route marker with cement concrete 1.2.4 (1 cement: 2 Coarse sand: 4 grades stone aggregate 20mm nominal size) of size 60cm x60cm at the bottom and 50cm x 50cm at the top with a thickness of 10cm including inscription duly engraded as required.

SCHEDULE ‘A’ PART-II (SCHEDULE OF ITEMS) PROVN OF UNDERGROUND CABLE OUTDOOR LT PANEL BD WITH ALLIED WKS AT LAITKOR

M&L for fabrication of outdoor type electrical panel board (CPRI approved) 415 volt ,3 phase, 4 wire system ,cubical, dust and vermin proof with base frame made out of CRCA sheet of 3.15 MM thick of size 1650X1650X800MM with both side opening double door system with locking arrangement, aluminium bus bar suitable for 1200 amp capacity and half for neutral on PVC/FRP insulated pads and panel board duly painted with two coat of metal powder coated paint of good approved quality including digital metering , volt meter selector switches, power indicator RYB LED lamps and Current Transformer of suitable ratio with consisting the following electrical fitment and making space and mounting arrangement for incoming/outgoing switch gears including necessary fixing/grouting arrangement on floor and trench and connecting all the disconnected underground power cables including lugging and ,crimping and cable glands where ever requires with testing and commissioning to the entire satisfaction of Engr-in-Charge :-embeded in PCC 1:4:8 type D-2 using 40mm graded stone aggragate of foundation as per manufacture instruction complete all as specified and directed comprising of the following controls i)ACB 800 Amps 4Pole Microprcessor Release IPR 1+ (Main Incoming). ii)MCCB 400 Amps 3Pole LS Frame : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA -02Nos. iii) MCCB 250 Amps 3Pole LS Frame : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA -02Nos. iv) MCCB 160 Amps 3Pole : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA -02Nos. v) Digital Volt Meter (o to 500Volt)-05Nos. vi) DIgital Amper Meter (0 to 800Amps)-05Nos. vii) CT 800/5A, Tape wounded, Cl-1-03Nos. viii) Selector Switch-10Nos. ix) Indicator Lamp (set of Three) -01 Set. Make: CPRI approved panel.

M&L for fabrication of outdoor type electrical panel board (CPRI approved) 415 volt ,3 phase, 4 wire system ,cubical, dust and vermin proof with base frame made out of CRCA sheet of 3.15 MM thick of size 1650X1650X800MM with both side opening double door system with locking arrangement, aluminium bus bar suitable for 800 amp capacity and half for neutral on PVC/FRP insulated pads and panel board duly painted with two coat of metal powder coated paint of good approved quality including digital metering , volt meter selector switches, power indicator RYB LED lamps and Current Transformer of suitable ratio with consisting the following electrical fitment and making space and mounting arrangement for incoming/outgoing switch gears including necessary fixing/grouting arrangement on floor and trench and connecting all the disconnected underground power cables including lugging and ,crimping and cable glands where ever requires with testing and commissioning to the entire satisfaction of Engr-in-Charge :-embeded in PCC 1:4:8 type D-2 using 40mm graded stone aggragate of foundation as per manufacture instruction complete all as specified and directed comprising of the following controls. i) MCCB 630Amps 4Pole of Adjustable Thermal & Fixed Magnetic, 415 Volt, 50 KA rms of breaking capacity 75% Frame LN (Main Incomer).-01No. ii) MCCB 400 Amps 4Pole LN Frame : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA (Frame LS) -01No. iii) MCCB 250 Amps 4Pole LN Frame : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA (Frame LS)-02 Nos. iv) MCCB 160 Amps 4Pole LN Frame : Adjustable thermal & Fixed Magnetic Ics 100% of Icu 36KA-01No. v) Volt Meter (o to 500Volt)-04Nos. vi) Amper Meter (0 to 800Amps)-04Nos vii) CT 630/5A, Tape wounded, Cl-1-03Nos. viii) Selector Switch -08Nos. ix) Indicator Lamp-03Nos Make: CPRI approved panel.

M&L for fabrication of outdoor type electrical panel board 415 volt ,3 phase, 4 wire system ,cubical, dust and vermin proof with base frame made out of CRCA sheet of 3.15 MM thick of size 1150X1250X450MM with front opening of aluminium bus bar suitable for 400 amperes capacity and half for neutral on PVC/FRP insulated pads and panel board duly painted with two coat of metal powder coated paint of good approved quality including digital metering , volt meter selector switches, power indicator RYB LED lamps and Current Transformer of suitable ratio with consisting the following electrical fitment and making space and mounting arrangement for incoming/outgoing switch gears including necessary fixing/grouting arrangement on existing floor and trench and connecting all the disconnected underground power cables including lugging and ,crimping and cable glands where ever requires with testing and commissioning to the entire satisfaction of Engr-in-Charge :-embeded in PCC 1:4:8 type D-2 using 40mm graded stone aggragate of foundation as per manufacture instruction complete all as specified and directed comprising of the following controls. i) MCCB 250 Amps 4Pole 36KA-01 No. ii) MCCB 160 Amps 4Pole 3KA -01No. iii) MCCB 100 Amps 4Pole 35KA -06Nos. iv) Volt Meter (o to 500Volt)-08Nos. v) Amper Meter (0 to 600Amps)-08Nos. vi) CT 250/5A, Tape wounded, Cl-1 -03Nos. vii) Selector Switch -16Nos. viii) Indicator Lamp (set of Three) -03Nos. Make: CPRI approved panel.

Supply & fix Bus bar Panel, Size:0.8x0.4x0.4 Mtr, Kisok outdoor type, CPRI type tested, LT 440 Volts, 50 Hz , 3 Phase 4 wire supply , floor mounted factory fabricated weather and vermin proof protection class IP 54 made out of 3.15 mm thick MS Sheet CRCA on angle iron 30X30X4mm frame of size suitable to incorporate following accessories with both side opening doors, locking arrangement powder coated internally and externally, shall have channel base of appropriate size and mounted on PCC foundation of size as required or approved by manufacturers in PCC 1:3:6 type C-2 , using 40 mm graded crushed stone aggregate as recommended by manufacturer or directed by the Engr -in - charge including earth work complete comprising of Bus bar chamber comprising 4 Nos Aluminium strip bus bars PVC insulated made of aluminium strip of size suitable for 200A current & 4 ways. PVC sheathed with colour coding with 100Amps 4Pole MCCB complete all as specified and Directed by Engr-In-Charge. Make: CPRI approved panel.

Laying of one number PVC insulated and PVC sheathed/XLPE power cable of 1.1KV grade of following size direct in Open/, Wall/ ground including excavation, sand cushioning, protective covering and GI Pipes as per site requirement and refilling the trench up to 35 Sqmm complete all as specified and Directed by Engr-In-Charge.Note: As Per Site Condition laying of Cable Open/Wall/Trench

above 35 Sqmm and upto 95 Sqmm

above 95 Sqmm and upto 185 Sqmm

Above 185 Sqmm and upto 400 Sqmm

Supply,only ARMOURED XLPE CABLE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty)with stranded aluminium conductor, 1100 volts grade, of size 3.5 Core 400 Sqmm. Make: Havells/ Polycab/ Closter

all as above item but 3.5Core 240Sqmm

all as above item but 3.5Core 185Sqmm

all as above item but 3.5Core 150Sqmm

all as above item but 3.5Core 50Sqmm

all as above item but 2Core 16Sqmm

Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

Supplying and laying 25 mm X 5 mm G.I strip at 0.50 metre below ground as strip earth electrode, including connection/ terminating with G.I. nut, bolt, spring, washer etc. as required. (Jointing shall be done by overlapping and with 2 sets of G.I. nut bolt & spring washer spaced at 50mm)

Supplying and fixing of light class G.I. pipe of 80 mm dia. (nominal) 3 metres length along the pole for protection of under ground cable as required.

Supplying and fixing of light class G.I. pipe of 50 mm dia. (nominal) 3 metres length along the pole for protection of under ground cable as required.

Providing and laying in position cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) in foundation of pump, DG set etc including form work etc as required.

Repair and replacement of automatic street light timer switch single phase , Frame Size 1, Max Load 6KW, Digital 24Hours , Contractor Rating (A) 32A TP, MCB Rating 40A SPN, HGS Smarty Series, incl Programmable Time Switch for SLP with complete circuit connection all as specified and directed by Engr-in-Charge. MAke : Havells/Indo-Asian/ or ISI Marked Approved by Engr -in-Charge. Make: Havells/ Polycab/ Closter

Supplying and making cable route marker with cement concrete 1.2.4 (1 cement: 2 Coarse sand: 4 grades stone aggregate 20mm nominal size) of size 60cm x60cm at the bottom and 50cm x 50cm at the top with a thickness of 10cm including inscription duly engraded as required.

Supply, laying & testing ARMOURED XLPE CABLE insulated, screened, PVC bedded, galvanized steel strip or wire armoured, electric power cables (heavy duty)with stranded aluminium conductor, 11000 volts grade, of size 3 core 120Sqmm. Make: Havells/ Polycab/ Closter

Laying of one number PVC insulated and PVC Sheathed/XLPE power Cable of 11KV grade of size up to 120Sqmm direct in ground including excavation, sand cushioning, protective covering and GI Pipes as per site requirement and refilling the trench etc as required.

Supply and fix cable jointing kit for 11 KV grade cable for in door termination, heat shrink type, joint complete with jointing material and accessories suitable for3 core XLPE, armoured, Al conductor cable of size 3core 120 sqmm. Make as per sample approval

Supply and fix cable jointing kit for 11 KV grade cable for outdoor termination , heat shrink type, joint complete with jointing material and accessories suitable for 3 core XLPE, armoured, Al conductor cable of size 3core 120sqmm. Make as per sample approval

Supply and fix cable jointing kit for 11 KV grade cable for straight through Heat/cold shrink type joint complete with jointing material and accessories suitable for 3 core XLPE, armoured, Al conductor cable of size 120 to 185 sqmm, Indoor/Outdoor type. Make : As per site requirement

Supply and installation of Outdoor type Ring main unit one incoming two outgoing SF6 filled load break switch each of 11 KV ,630 Amp.including base foundation with all accessories all as specified by Engr-In-Charge. Make: Havells/ Polycab/ Closter

Earthing with copper earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

Providing and fixing 25 mm X 5 mm copper strip in 40 mm dia G.I. pipe from earth electrode including connection with brass nut, bolt, spring, washer excavation and re-filling etc. as required.