Water Resources Department Tender

Item no.4 Providing and constructing 150 mm thick Quarry Spalls of approved trap stone quality of specified thickness from approved source including cost of all materials, labour, machinary etc.complete with lead upto 1 km and all lifts as directed.

Item no.5 Providing and constructing 300 mm thick dry rubble stone pitching with pin headers at 2 per sqm using stones and stone chips from approved source including cost of all materials, labour, machinary ,hand packing / wedging stone chips, finishing etc.,complete with lead upto 1km and all lifts as directed.

Item No.6 Providing and constructing 300 mm thick dry rubble stone pitching with pin headers at 2 per sqm using stones and stone chips from approved source including cost of all materials, labour,machinary ,hand packing / wedging stone chips, finishing etc.,complete with lead upto 1km and all lifts as directed.

Item No.7 Providing and fixing canal information board of 1.2x0.75 m prepared on 16 gauge M.S. sheet with angle iron frame of size 35x35x3 mm with cross bracing of size 25x25x3 mm including painting with one coat of zinc chromate storing primer and two coats each of green/white back ground and back side grey store enamelled bonded with red retro reflective sheet Engineering grade, border/letters/numeral / arrows coated with non pealable crystal clear protective transparent coat retaining 100% reflection including two angle iron post of size 50x50x5 mm of 3.65 m long inflated at bottom drilled on top and painted in white and black bonds of 30 cm with four numbers high strength of G.I. bolts and nuts of size 10 mm dia. and 20 mm long sheet and angle iron post in one piece without joints including all taxes, conveying, fixing in ground with cement concrete in M-15 block of size 60x60x75 cm as directed.

Item No.8 Providing and fixing gauge plate of FRP sheet very sturdy both sides, gelcoat finish composite material, sandwich with M S strip by contact moulding process, engraved moulded bandwidth and figures with computerised gauge marking with reflective radium pasting, spray lamination with polyurethane chemical for surface protection including material reqd for fixing, nut bolts, washers, Nylon rope, hanger, drilling machine etc. complete as directed.

Item No. 9: Cutting down trees including cutting trunks & branches and stacking the material with all lift including uprooting and refilling the pit with material etc. complete as directed. (excluding extra material required for refilling)above 90 cm to 1.5 m. girth