Local Self Government Department Tender

75.5.1.1pb : Prime Coat - Low porosity - With Packed Bitumen Rates br Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per Technical Specification Clause 502

75.5.2.1pb : Tack Coat - With Packed Bitumen Rates br Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.20 to 0.25 kg per sqm on the prepared bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503.

75.5.2.3pb : Tack Coat - With Packed Bitumen Rates br Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.25 to 0.30 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503.

75.5.9.1.2pb : 20mm thick Open-Graded Premix Carpet using Bituminous (penetration grade/modified bitumen) Binder - Bitumen S-65 - Packed Bitumen Ratesbr Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type A or Type B or Type C as per Technical Specification Clause 508. br Case - I By Manual Means br (II) Bitumen (S-65)

75.5.12.A.3.2pb : Seal Coat - Manual Means - Type C - Bitumen S-65 - Packed Bitumen Rates br Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A, Type B and Type C as per Technical Specification Clause 510 br A. By Manual Means br Case III : Type C br (II) Bitumen (S-65)

od678882/2020_2021 : Surface dressing of the ground in all kinds of soil including removing vegitation and inequalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50m and lift up to 1.5m

od678888/2020_2021 : :Plain cement concrete pavement ,thickness as per design,over a prepared sub base,<br>with 43 grade cement or any other type as per clause 1501.2.2 M 20 (grade),coarse and fine aggregates<br>conforming to IS383, maximum size of coarse aggregate not exceeding 25mm mixed in a concrete mixer of<br>not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design,laid in approved<br>fixed side formwork(steel channel, wedges,steel plates including levelling the formwork as per<br>drawing),spreading the concrete with showels,rakes,compacted using needle vibrator and finished in<br>continuous operation including provision of contractionand expansion ,construction joints curing of<br>concrete slabs for 14 days, water finishing to lines and grade as per drawing and TechnicalSpecifications<br>clause 1501 (form work excluded