Local Self Government Department Tender

4.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)

50.2.25.1:Filling with contractor's own earth ( excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m as per direction of site Engineer-in-charge

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

OD383852/2024-2025:Steel work for purlin/single section with Mild steel tubes hot finished welded type including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete(modified 50.10.2)

OD383853/2024-2025:51.20. Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by Engineer-in-charge) 0.35 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side. of the sheet and polyester top coat 15-18 microns.Sheet should have protective guard film of 25 microns minimum to avoid scratchesduring transportation and should be supplied in single length upto 12 metre or as desiredby Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws ofsize (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical orcurved surfaces, excluding the cost of purlins, rafters and trusses and including cutting tosize and shape wherever required.

9.48.2:Providing and fixing M.S. Grills of required pattern in frames of windows etc. with M.S. flats, square or round bars etc. including priming coat with approved steel primer all complete.Fixed to openings/ wooden frames with rawl plugs screws etc

13.61.1:Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work

ELECTRICAL WORK 90.12.5.46:Supply & laying of one number PVC insulated and PVC sheathed armoured aluminium power cable of 1.1KV grade of the following sizes in the existing RCC/ HUME / STONE WARE/ GI/ DWC pipe as required.4 core 95 sq mm

9.1.24:Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed / XLPE aluminium conductor cable of 1.1 KV grade as required.3 1/2X 95 sq. mm (45mm)

90.12.9.5:Supplying, laying and jointing of the following sizes of double wall corrugated (DWC) pipes made out of HDPE conforming to IS 14930 Part II for mechanical protection to underground power cables with all required accessories in ground in the existing trench90/75 mm or nearest size

OD380068/2024-2025:Distribution Panel Board of appo. size 1480 X1200X 250 mm :- Supply, fabrication, erection, testing and commissioning the following floor/wall mounted free standing cubicle type fully compartmentalised (Busbar chamber, Cable chamber, 9Nos Single phase Energy meter chamber, 1No.three phase SFU chamber and 9 Nos. single phase SFU chamber ) dust tight, vermin proof LT panel boards fabricted out of 16SWG CRCA sheet and powder coated as per IS standards . The Board shall be completed with phase indication lamps in the incoming, suitably rated TPN Aluminium Busbars and earth bus of adequate capacity, double earth connection to all switches, intenal rigid connection etc. (Incomer:- 125A TPN ISOLATOR with HRC fuse -1No.,TPN Al. Busbar as per ISS, Outgoing :- 32A single phase SFU with HRC fuse 9 Nos and 32A kitkat fuse unit 9 Nos .)

OD380103/2024-2025:Main LT Panel Board MSB with common facility metering: size1600 X 1100 X 250 mm : Supply, fabrication, erection, testing and commissioning the following floor/wall mounted free standing cubicle type fully compartmentalized ( Busbar chamber, Cable chamber, 400/320A 4Pole MCCB as Incomer, 1No 125 TPN Cubical SFU With HRC Outgoing for Metering chamber, 4Nos 63A TPN SFU + 63A Cutout Outgoing, 3Phase Metering & 3Nos 125A TPN Cubical SFU Outgoing Main Panel Board, 1No.three phase Energy meter chamber, 6 Nos. three phase SFU chamber ) dust tight, vermin proof LT panel boards fabricated out of 16SWG CRCA sheet and powder coated as per IS standards . The Board shall be completed with phase indication lamps in the incoming, suitably rated TPN Aluminium Busbars and earth bus of adequate capacity, double earth connection to all switches, internal rigid connection etc. (Incomer:- 400/320A 4Pole MCCB -1No.,TPN Al. Busbar as per ISS, Outgoing :- 125 TPN Cubical SFU with HRC for metering Chamber-1 No., 125A TPN Cubical SFU for single phase metering panel board-3, 63A TPN SFU + 63A Cutout Outgoing+ metering chamber- 4 Nos.)

OD380160/2024-2025:Supplying and Fixing Compartmentalized panel board (SSB) of size 800x1100x250mm (Busbar chamber,1 Nos.125A 4Pole Change Over + 2 Set RYB Indicator as Incomer, 3 Nos 63 TPN Cubical SFU With Hrc & 100A TPN Isolator as Outgoing) Common Facility Panel Board made of CRCA sheet 16SWG and powder coated as per IS standards. The Board shall be completed with phase indication lamps in the incoming, suitably rated TPN Aluminium Busbars and earth bus of adequate capacity, double earth connection to all switches, internal rigid connection etc. The panal board directly fixing on wall using proper bolts ,nuts etc. and making good the surface of wall etc. complete