Kerala State Industrial Enterprises Limited Tender

OD7725/2024-2025:L-Shaped Workstation cum file storage (1800mm x 600 mm) + (1200mm x 450mm) : Providing and fixing L- Shaped Workstation as per following specifications : Modular Partition: 56 mm thickness modular partition frame work made out of 56 Aluminum partition panel minimum thickness of 1.5 mm powder coated 50 microns frame work designed to carry out electrical power and computer wiring in 2 different race ways with a separation of at least 300mm between them including necessary slots. The frame work consists of minimum two vertical upright a top horizontal section, bottom section and intermediate sections (minimum 40 mm x 30 mm) The frame structure covering and Top trim / side trim made out of Aluminum with powder coating (50 microns). All Aluminum Horizontal and vertical sections are extruded from AA 6063 American standard alloy with 12 HRC hardness of Architectural grade (IS 10259:1982) of 18 gauge minimum. The thicknesses of extruded sections vary based on its design and its point load bearing design engineering. The skinning / panels / tiles to be of 9mm thick Prelaminated particle Board (Grade II and Type-II, IS 12823: 1990; Reaffirmed 2005) till 1200mm height from the floor level for outside facia. Inside facia fabric panel with soft board with minimum 9mm thickness above table top (450 mm height). 9mm thick Prelaminated particle board panel finished with 0.8mm thick laminate from floor level to top of table top (750 mm height). The edges to be capped (as per approved design and drawing) Aluminum end trim with powder coating. Cost to include that for provision of fixing switches and the necessary cut out for the same. The height of the partition to be 1200mm. As per drawing and direction complete with all standard fittings and fixtures, leveling screws etc. Cost to include the supporting system to partitions and walls such as brackets / fasteners / joining posts / aluminum race ways 2 nos / wire management cleats / runners etc.

OD7723/2024-2025:L-Shaped Workstation cum file storage (1800mm x 600 mm) + (1200mm x 450mm) : Providing and fixing L- Shaped Workstation as per following specifications : Table Top: Providing and installing 600mm deep Table top made of 25mm thick pre laminated particle board Grade II and Type-II (IS 12823: 1990; Reaffirmed 2005) finished with 0.8 mm thick laminate, all exposed edges finished with 2mm x 25mm PVC hot pressed lipping of approved profile, all of approved shade and colour. Rates are inclusive of fixing to the partition with necessary powder coated heavy duty MS brackets, cleats etc. for supporting table tops and rates shall include that for 1 nos. matching to top, ABS wire manager (standard size) per work station, complete as per drawings and direction.

OD7722/2024-2025:L-Shaped Workstation cum file storage (1800mm x 600 mm) + (1200mm x 450mm) : Providing and fixing L- Shaped Workstation as per following specifications : Pedestal: Providing and installing drawer boxes of size 585mm ht., 390mm width and 500mm deep, top made out of 18mm thick pre laminated particle board Grade II and Type-II (IS 12823: 1990; Reaffirmed 2005) finished with 0.8mm thick laminate, front and sides made of 18mm thick pre laminated particle board Grade II and Type-II (IS 12823: 1990; Reaffirmed 2005)finished in 0.8mm thick laminate and back, drawer bottom to be 6mm thick particle board with.08mm thick laminate. 2 nos. minimum 120mm high drawer and 1 minimum 275mm high filing drawer with 4 nos. Nylon Spacers 10mm ht. with single key lock mechanism / SS telescopic channels and provided with handle and necessary fixtures (heavy duty high performance) as directed.