Kerala Small Industries Development Corporation Limited Tender

Gypsum Ceiling Work providing and fixing fall ceiling at all height including providing and fixing of frame work made of special sections, power pressed from M.S. sheets and galvanized with zinc coating and consisting of angle cleats with flanges centre to centre, one flange fixed to the ceiling with dash fastener bolts, other flange of cleat fixed to the angle hangers of required length with nuts & bolts of required size and other end of angle hanger fixed with intermediate G.I. channels running centre to centre, to which the ceiling section with tapered flanges having lips centre to centre, shall be fixed in a direction perpendicular to G.I. intermediate channel with connecting clips G.I. wire at every junction, including fixing perimeter , the perimeter of ceiling fixed to wall/partition with the help of rawl plugs at centre, with drywall screws including fixing of gypsum board to ceiling section and perimeter channel with the help of drywall screws of size, including jointing and finishing to a flush finish of tapered and square edges of the board with recommended jointing compound , jointing tapes ,grills, diffusers, cutouts made with frame of perimeter channels suitably fixed. With Painting etc…

Modular Workstation for Staff Providing and fixing of modular partition 75 mm thick for employees and cabin cubicals 50-60 microns powder coated CRCA partitions with pre punched cut outs to run electric & networking cables. Dual Race ways with punch-out to fix electrical and data modules for power & data at skirting level & just below table top, Writing board (White Board), Pin up board (Soft Board ). Partitions are covered with 9mm tiles (Pre laminated particle Board/Fabric Cladded Board) as required by using sliding panel method, Level Adjusters and all the visible edges of partitions are covered with curved Aluminum trims.Supply and installation of free standing straight table of size 1000x500x750/(1000 partition ) (or nearest size) The Table Top shall be made of 25mm thick side leg 18mm MDF Double side laminated board with PVC edge band lipping. CPU tray and Keyboard tray one Drawer and Cupboard Shall be provided. The rate shall be inclusive of cost and conveyance of all material, labour, transportation, loading - unloading charges and complete Keyboard Supplying & Fixing practical injection moulded keyboards under the worktop with Telescopic channels

Storage Fully made with 18mm thick prelaminated particle board, knock down fitting, visible edges are lipped with 5mm PVC edge band, vertical support to be provided at an intervel of 80-90cm & horizontal pannels to be provided at an intervel of45 cm. Providing Size: 900X450X1200(h)

Front Cabin Partition 3 Seater Using 9mm thickness Double Side Lamination HMR Board full 75mm Thickness with support for wood pieces with full covering this area Central Partition Using Glass 6 mm thickness Support with Wooden Frame high quality Comfortable Very durable Board

Electrical Work Power Point Outlets Supply & Installation of 3 Nos of 6A Sockets controlled by 2 Nos 5 A Switches with front plate with enclosure and other accessories etc..(Mk /Roma/Crabtree) a) 3Runs of 2.5sqmm copper wire in PVC conduit for circuit mains b) 3Run of 2.5sqmm copper wire in PVC Conduit for Power points c)     3 Run 1.5 Sqmm Copper using light point and fan point d) Light led tube e) Wall Fan new With Networking Main Switch to Switch Cable Laying For Cat 6/6 UTP/

Old Partition Dismantling to using Inside Cabin Old partition using inside cabin and fixing working Area