Kerala Electrical And Allied Engineering Company Limited Tender

5.9.1 : Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

5.22.6 : Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelThermo - Mechanically Treated bars of grade Fe-500D or more

5.1.3 : Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size)

2.25 : Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundation etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.

ELECTRICAL WORK

od205196/2023_2024 : Supply of LED Floodlight luminaire with greater than 53,000 Lumens Light output and Power consumption not more than 400W (+/-5w), greater than 130 Lumens per watt system efficiency, 75,000 Burning hours as per L70. The fitting shall have IP66 with IK08 Protection, 500 hours NSS Salt spray tested finish coating on non corrosive ADC12 grade single piece diecast Aluminium housing and Polycarbonate cover. CRI>70 and Ripple value should be less than 10%. The Luminaire should have 20 KV /10 KA SPD duly bolted in the Luminaire and the SPD should be able to sustain a minimum 15 hits of 10KA rating i.e. Total of 45 hits across all the three modes as per IEEE 62.41.2 standards, Operating voltage of 120-270, 440V Phase to Phase protection for 8 hours. The fitting shall be suitable for dimming via coded mains receiver. The luminaire and Driver shall be saperately BIS Approved of same brand similar to Philips or Techno- Commercially equivalent approved by engineer in-charge.

od205193/2023_2024 : Supply and installation of 16mtr fixed type Stadium mast suitable for mounting 15nos luminaires, made of Hot- dip Galvanisation process as per IS 4759:1996 with monkey climbing arrangement with all accessories similar to Philips 16mtr Stadium Mast or Techno- Commercially equivalent approved by engineer in-charge.

90.6.5.13 : Supply and drawing the following sizes of multi-core PVC insulated & FRLS PVC sheathed 650/1100 V grade copper conductor round flexible cables conforming to IS 694 part I 1960 in the existing surface / recess conduit as required including giving necessary connections of the following sizes.

90.12.5.41 : Supply & laying of one number PVC insulated and PVC sheathed armoured aluminium power cable of 1.1KV grade of the following sizes in the existing RCC/ HUME / STONE WARE/ GI/ DWC pipe as required.

1.17.12 : Supplying and drawing following sizes of FRLS PVC insulated copper conductor, single core cable in the existing surface / recessed steel/ PVC conduit as required.3 x 2.5 sq. mm

od205248/2023_2024 : Supply and laying of 25mm GI Flexible pipe suitable for laying 3c x 2.5 sq mm PVC insulated PVC sheathed flexible Copper conductor Cable as required.

90.12.10.2 : Supply & laying of DWC pipe in ordinary soil 0.75m below ground level including excavation

90.16.1.3 : Supply and drawing bare earthing conductors of the following sizes along with wiring/ cables and giving connection as required

90.16.5.3 : Supply of superior quality copper earth socket for the following size of earth conductor including crimping etc. as required.

od205246/2023_2024 : Supply and fixing IP66 cable junction box including Terminal block connectors suitable for cable up to 16 sq. mm cable etc for outdoor application of size 155 x 210 x 92mm (Hensel make model KF 1616 G / equivalent make).

5.4 : Earthing with G.I. earth plate 600 mm X 600 mm X 6 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required.

od205249/2023_2024 : Earthing with G.I. earth pipe 2.5 metre long, 40 mm dia including accessories, with providing masonry enclosure with cover plate . ( but without charcoal/ coke and salt ) etc as required.

90.14.5 : Supply and fabrication conveyance and installation of angle iron frame work for wall mounting panel board

od205250/2023_2024 : Supply, installation, testing &commissioning of totally enclosed free-standing floor mounting dust & vermin proof indoor cubicle type IP42 panel board suitable for 415V,3 phase, 50Hz supply with provision for fixing incoming & outgoing switches fabricated using 2 mm MS sheet powder coated with necessary cable alley & bus bar chamber for all switches. The panel shall be with all accessories as per drawing & specification. (Refer particular specification). Incomer, 100A, 4 pole On-Load Change Over Switche1nos.,Din type HRC fuse unit, neutral link etc. - 1No, 4A, C curve SP MCB - 3 nos, RYB indication lamp, LED type -3nos , The panel shall be provided, TPN busbar chamber with Aluminium busbar

2.13.2 : Supplying and fixing following rating, four pole, 415 volts, isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required.63 amps

2.15.2 : Supplying and fixing following rating, four pole, (three phase and neutral), 415 volts, residual current circuit breaker (RCCB), having a sensitivity current 30 mA in the existing MCB DB complete with connections, testing and commissioning etc. as required.40 amps

2.10.1 : Supplying and fixing 5 amps to 32 amps rating, 240/415 volts, "C" curve, miniature circuit breaker suitable for inductive load of following poles in the existing MCB DB complete with connections, testing and commissioning etc. as required.Single pole

90.14.10.4 : Supply, conveyance and fixing the following types & current rated control gears & switchgears conforming to IS 13947 suitable for 440 V, 50 Hz, AC supply in the existing panel assembly as required.

od205253/2023_2024 : Design,Supply, installation, testing and commissioning of outdoor duty (IP 54) wall mounted type weatherproof ,double door type KSEB metering panel , suitable for accomodating KSEB energy meter (supply of energy meter is under KSEB scope) with locable door having glass window, sealing facility for KSEB, top cover and necessary overhang, undergone seven tank process, powder coated finish and all mounting accessories as required complete .The panel shall be with all accessories as per specification.

2.1.3 : Providing and fixing following capacity TP&N disconnector fuse switch unit inside the existing panel board with ISI marked HRC fuses including drilling holes in cubicle panel, making connections, etc. as required.100 Amp TP&N

od205349/2023_2024 : Supply and fixing of Granite Plaque engraved with the name of MP , name of Project,Name of Plan, Location, Name of LSGD ,Year of Project, Estimate Cost and Name of implementing agency.

Amount to be deposited to KSEB For availing service Connection including laison charges (Actual amount to be reimbursed on production of original receipt, laison charge as per recommendation of KEL engineer in charge)

od205350/2023_2024 : Supply and fixing of Name Board of MP with Angles , Flats, Square Pipe, ACP Sheet (complete 4 sides) including Nut and bolt