Irrigation Department Tender

50.2.26.1:Filling with contractor own earth (excluding rock) in open areas in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m as per direction of site Engineer-in-charge.

OD14931/2024-2025:Filling up low laying and water logged areas with local materials/quarry muck, spreading in layers, levelling the top at site and consolidation by ramming etc complete for improving the CBR value of subgrade

2.6.1:Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including disposal of excavated earth, lead up to 50 m and lift up to 1.5 m, disposed earth to be levelled and neatly dressed.All kinds of soil

4.1.5:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:3:6 (1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size)

5.22.4:Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelHot rolled deformed bars

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

13.46.1:Finishing walls with Acrylic Smooth exterior paint of required shade:New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm)

10.1:Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

13.61.1:Painting with synthetic enamel paint of approved brand and manufacture to give an even shade:Two or more coats on new work

OD30969/2023-2024:Name board of size 75X60 cm installed in the appropriate place visible to the public made of brick wall with granite plaque should be inserted and engraving letters etc. complete as per departmental officers at site.

13.71:Lettering with black Japan pint of approved brand and manufacture

OD17590/2024-2025:Manufacturing, supplying and fixing sign boards of size 1.2 x 0.6m made up of 2 mm thick Japan sheet, support frame of M.S. angle iron of size 25x25x3 mm to 2 vertical posts 2.2m long made up of M.S. Tee section ISNT 40x40x6 mm welded with base plate of size 100x100x5 mm at the bottom end and including making holes in pipes, angles flats, providing & fixing M.S. message plate of required size, steel work to be painted with two or more coats of synthetic enamel paint of required shade and of approved brand & manufacture over priming coat of zinc chromate yellow primer .Backside of sheet to be painted with two or more coats of epoxy paint over and including appropriate priming coat and firmly fixed to the ground after excavation by means of properly designed foundation of size 0.25x0.25x0.45m with CC 1:2:4 using 20mm broken stone including all cost and conveyance of materials, labour charges, leads and lifts etc. complete as per drawing , specification and direction of Engineer--in-charge. (excluding lettering which is paid separately)