Indian Institute Of Information Technology And Management Tender

CANOPY

Supply and installation of Canopy with polycarbonate multi-layered system (Canopy size 5.875m X 14.15m approx.), a complete assembly of extruded multilayer UV protected polycarbonate panels. Co-extruded UV protected polycarbonate panel system of min 18 mm thick panel of 1200 mm width for bigger spans and minimal junctions for better performance. Panels shall have minimum seven layers with all fixing accessories to ensure best performance for wind uplift, vibration, oil canning and visual appearance. Panels shall be manufactured with vertical offset standing seam at both sides of the panel. Panels have to be fixed on Purlin with snap on connectors with grip lock locking mechanism and will be secured on MS structure with 3 numbers self-drilling screws & trapezoid SS fasteners holding the base of the standing seam offering best stability having a pull-out load of min. 7000N (7KN) tested as per ISO 6892:1998 and IS 1608: 2005. Panels must satisfy Dart drop impact test as per IS 14443-97 shall show no sign of breakage on Polycarbonate Panel which have been exposed to UV for a min. of 500 Hours as per ASTM G 155. Panels shall not have Yellowness Index as per ASTM D 1925 of 15 units when tested on a sample exposed to UV for 500 Hours as per ASTM G 155. U value shall not be more than 2.0 W/m2K as per EN ISO 10077-2:2018.Panel shall be with additional End cap/Aluminium U/F profile/ Glazing Bar for ends as required. Panel shall be fixed over cantilever MS structural steel supported with SS rods, the canopy shall be held with required Fittings and SS rods (of approved manufacture) connected with beams for supporting the canopy structure with fixing assembly of steel structural section. The canopy shall be connected to existing RCC beam by means of SS- 316 Grade stainless steel brackets & Anchor bolts at the horizontal side including non-staining weather sealants of approved make, Teflon/ nylon bushes and separators, all complete as per approved drawings. The joints between canopy and wall attached with it, is to be filled with non-staining weather sealant, so as to make the entire system fully water proof & dust proof. as per approved architectural drawings. Trained and factory authorized labour with supervision to complete the entire panel installation as per drawing & direction of the engineering in charge. The rate shall include all labour, T&P, scaffolding, other incidental charges including wastage, enabling temporary services all fitting fixers nut bolts, washer, Buffer plates, fastener, anchors, SS channel , suspended SS Rod etc. all complete.

ELECTRICAL LUMINAIRE AND WIRING