Rural Drinking Water And Sanitation Department Tender

004 - Supply and delivery at site of brand new best make non-return valve as per IS 778/1984 with ISI Mark and as per its latest amendments (CSR 2023-24, VOL-5, Chapter-13, P.No. 154, I.No.13.25)

005 - Supply, installing,testing and commissioning COMMON control panel consisting of the following INCOMING:1 No set of Phase indicating lamps with SFU of suitable rating 1 No, Analog Ammeter, 1 No Analog Voltmeter 1ni with Phase selector switch, Isolating switch OUTGOING for Main Electrical Pump: 1 No. MCB 1 No. DOL of S/D Starter suitable for respective HP 1 No. Electrcal Protection Like single Phase preventor, under voltage over Volage, under current over current & dry run protection suitable for the pump described above 1 no Indoor type NOTE: 1) DOL- Direct Online Starter 2) S-D- Star Delta Starter etc. complete. 6 to 15 HP pumps (CSR 2023-24, VOL-5, Chapter-13, P.No. 155, I.No.13.23.3)

006 - Supply and delivery at site 50mm(2”) dia heavy duty unplasticized PVC Column pipes with heavy duty collars,rubber profile ring,vibration control profile ring,freezing and turbulence free leak proof EPDM ring with ISI mark with its latest amendments (CSR 2023-24, VOL-5, Chapter-13, P.No. 155, I.No.13.28)

007 - Supply and delivery at site Accessories for Single Phase pumpset like SS Groove Nipples,SS Studs & Nuts,Screw Clips &water proof Insulation Tape etc complete with ISI mark (CSR 2023-24, VOL-5, Chapter-13, P.No. 155, I.No.13.30)

008 - Supply and delivery at site Stringing of heavy duty Naylone/PP rope with ISI etc complete suitable for Single phase Pumpsets. (CSR 2023-24, VOL-5, Chapter-13, P.No. 155, I.No.13.31)

009 - Providing main connection from pole PVC insulated sheathed steel wire cable in new trench as per IS 1554/ 1988 with latest amendments with ISI mark from KPTCL pole to meter board unit. (CSR 2021-22, VOL-5, Chapter-13, P.No. 156, I.No. 13.36)

010 - Labour charges for Erection, Electrification and commissioning of Pump sets, including aligning and balancing of all items including supply and erection of two pair of supporting clamps, bore well caps, cable clips and water tight gland cable protectors, bolts, nuts, valve and gauges,tools and equipments etc., involved in the job as per specifications, with necessary tests as per specifications, with testing of as per instructions of engineer incharge of work. (CSR 2021-22, VOL-5, Chapter-13, P.No. 156, I.No. 13.32)

011 - Labour charges for erection of indoor type panel board and meter board units with all necessary materials and labour tools and equipments including cement concrete for foundation/bed etc,complete as per specification, with testing of as per instructions of engineer incharge of work. (CSR 2023-24, VOL-5, Chapter-13, P.No. 156, I.No. 13.32)

012 - Labour charges for providing connection using insulated sheathed steel wire cable as per IS 1554 1988 with latest amendments from KPTCL pole to meter board unit, with all necessary materials ,tools and equipments,as per specificationswith testing of as per instructions of engineer incharge of work 6mm

013 - Providing and fixing suitable for 1.1 KV class UG cable filled with necessary bitumen/insulating compound complete with terminals, clamps,bolts,nuts and washers etc. with necessary materials and labour tools and equipments as per instructions of engineer incharge of work.

014 - Earthing: Providing and fixing and wiring earth electrode for grounding circuits IC cutouts and other equipments on the meter board in the pit. The pits should be filled up with equal proportion of salt and charcoal 150mm around the pipe to complete depth. The connection from the pipe to the conduits etc. is to established through GI wire of sizes as per clause 7.3.3 of IS 732 using 12mm bolts, nuts, washers and check nuts, the pipe shall have 16 through holes of 12mm dia. (CSR 2023-24, VOL-5, Chapter-13, P.No. 157, I.No. 13.39)

015 - Earth work excavation for pipelines/cables by Manual means upto 600 mm trench width, as per drawing and technical pecifications, including setting out, shoring, strutting, arricading, caution lights, removal of stumps and other deleterious matter, including dressing of excavated surfaces, disposing off or leveling the excavated earth or sorting & stacking the selected earth for reuse in a radius of 50 m. Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering and lift upto 1.5 m including cost of labour, tools, usage& other appurtenances required to complete the work. (CSR Vol-1 2023-24, Chapter -1, It No-1.6.1, , Pg No-06)

016 - Providing PVC ringtite pipes conforming to IS 4985:2000 with latestamendments and conveying to worksite, rolling and lowering into trenches, laying true to line and level and perfect linking at joints, testing and commissioning, including loading unloading at both destinations and cuts of pipes wherever necessary including jointing of PVC pipes and specials (excluding cost of specials) with jointing of approved type, with all labour with all lead & lift including encasing the pipe alround to a depth of not less than 15 cms. with soft gravel or selected earth available from the excavation etc. complete and giving necessary hydraulic test to the required pressure as per ISS (Contractor will make his own arrangements for procuring water for testing) etc. complete For: PVC pipes 75mm dia., 6 kg/sqcm & class 3 (CSR Vol-5 2023-24, Chapter -10, It No-10.1.5, Pg No-113)

017 - Refilling available earth around trenches/pipelines, cables in layers not exceeding 20 cms in depth, compacting each eposited layer by ramming after watering with a lead upto 50 m, and lift upto 1.5 m. Including cost of all labour complete as per specifications (CSR Vol-1 2023-24, Chapter -1, It No-1.10, , Pg No-07)

018 - Supply and delivery at site special moulded variety PVC elbows as per IS 7834/ 1987 and fabricated as per IG124/ 1984 with ISI mark with its latest amendments (CSR Vol-5, 2023-24, Chapter -10, It No-10.9.6, , Pg No-117)

019 - Supply and delivery at site special moulded variety PVC tee as per IS 7834/ 1987 and fabricated as per IG124/ 1984 with ISI mark with its latest amendments 10.10.1 110 mm dia PVC Tee Each (CSR Vol-5, 2023-24, Chapter -10, It No-10.10.6, , Pg No-117)

020 - Supply and delivery at site special moulded variety PVC bend as per IS 7834/ 1987 and fabricated as per IG124/ 1984 with ISI mark with its latest amendments (CSR Vol-5, 2023-24, Chapter -10, It No-10.11.6, , Pg No-118)

021 - Supply and delivery at site special moulded variety PVC service saddles as per IS 7834/ 1987 and fabricated as per IG124/ 1984 with ISI mark with its latest amendments (CSR Vol-5, 2023-24, Chapter -10, It No-10.12.6, , Pg No-119)

022 - Providing air valve confirming to IS 1538 (Part- I to XXII) 1978 with latest amendments if any RWS/19-20/Pg No-317 / Item No 15.60)