Rural Development And Panchayat Raj Department Tender

code04 - Providing Size Stone masonry with hard stone in foundation and plinth with Cement mortar 1 6 1 cement 6 coarse sand P No 6 I No 5 4 of PWD SR 2023 24 Vol 2

code05 - Providing and laying in position Reinforced cement concrete for all Foundation works The granite trap basalt crushed graded coarse aggregates and fine aggregates as per relevant IS Codes machine mixed with super plasticizers laid in finished layers well compacted using needle vibrators including all lead and lifts cost of all materials quality confirming to the requirements of relevant IS codes labour Usage charges of machinery curing and all the other appurtenances required to complete the work as per technical specifications The cost of steel reinforcement and formwork to be paid separately P No 2 2 1 1 I No A 67 of PWD SR 2021 22 2 2 1 1 M20 Design Mix Using 20 mm and down size graded crushed coarse aggregates

code06 - Providing and constructing load bearing wall with Solid Concrete blocks of size 400x150x200mm having block density more than 1800kg m3 and minimum compressive strength of 4 00 N mm2 conforming to IS 2185 Part I 2005 and constructed with CM 1 4 as per IS 2572 2005 including cost of all materials labour scaffolding and curing usage charges of machinery etc complete as per specifications P No 17 I No 6 33 of PWD SR 2023 24

code07 - Supplying fitting and placing TMT FE 550 550D Steel Reinforcement including cost of all materials machinery labour cleaning straightening cutting bending hooking laping welding joints tying with binding wire soft annealed steel wire and other ancilary operations complete as per drawing and technical specification P No 18 I No 2 11 of PWD SR 2023 24 a Buildings

code08 - Providing and fixing Chlorinated polyvinyl Chloride CPVC Pipes having thermal stability for hot cold water supply including all CPVC plain and brass theraded fittings incluing fixing the pipe the pipe with clamps at 1 00m spacing This including jointing of pipes and fitting with one steps CPVC solvent cement and testing of internal work Exposed on wall P No 122 I No 13 31 2 20 mm nominal dia Pipes

code09 - Filling available excavated earth excluding rock in trenches plinth sides of foundations and other similar works etc in layers not exceeding 20cm in depth consolidating each deposited layer by ramming and watering lead up to 50 m and lift upto 1 5 m P No 7 I No 1 9 of PWD SR 2021 22

code10 - Providing 12 mm cement plaster with cement mortar 1 4 1 cement 4 fine sand to brick masonry including rounding off corners wherever required smooth rendering providing and removing scaffolding including cost of materials labour curing complete as per specifications and as per directions of Engineer in charge P No 41 I No 8 1 1 of PWD SR 2021 22

code11 - Distempering with dry distemper of approved brand and manufacture one coats and of required shade on old work to give an even shade as per specifications and as per directions of Engineer in charge P No 35 I No 8 58 of SR 2021 22

code12 - Providing and fixing 1mm thick M S sheet door with frame of 40x40x6 mm angle iron and 3 mm M S gusset plates at the junctions and corners all necessary fittings complete including applying a priming coat of approved steel primer Using M S angels 40x40x6 mm for diagonal braces including cost of materials labour usage charges of machinery complete as per specifications and as per directions of the Engineer in Charge P No 75 I No 11 5 1 do with both side prelam

code13 - Applying priming coat With ready mixed red oxide zinc chromate primer of approved brand and manufacture on steel galvanised iron steel works including preparing the surface after thorougly cleaning oil grease dirt and foreign matter cost of materials labour complete as per specifications and as per directions of Engineer in charge P No 47 I No 8 34 3

code14 - Painting Steel work with Deluxe Multi Surface Paint to give an even shade Two coat applied at 0 90 ltr 10 sum over an under coat of primer applied at 0 80 ltr 10 sum of approved brand and manufacture including preparing the surface after thorougly cleaning oil grease dirt and foreign matter cost of materials labour complete as per specifications and as per directions of Engineer in charge Page No 47 Item No 8 33 3 of SR 2021 22

code15 - 12 55 Providing and fixing 30mm thick factory made rigid foam Prelam Panelled Door Shutters made from M S tube of 19x19mm 19 gauge for stiles and 15x15mm for top and bottom rails covered with heat moulded Prelaminated PVC C Channel of 5mm thick sheet and 30x50mm wide to form stiles and 5mm thick and 75mm wide Prelaminated PVC Sheets for top rail lock rail and bottom rail on either side and 5mm thick 20mm wide cross PVC sheet as gap insert for top rail and bottom rail Panelling of 5mm thick PVC sheet Prelaminated on either side fitted in the M S frame Sealed to the stiles and rails with PVC Designer beading on either side and joined together with solvent cement adhesive etc Complete as per manufacturers specification and direction of Engineer in charge fixed to frames with 3 nos of 75mm Aluminium hinges P No 105 I No 12 55 1 do with both side prelam

code16 - Providing and laying Ceramic glazed floor tiles of size 300x300 mm thickness to be specified by the manufacturer of 1st quality conforming to IS 15622 of approved make in colours such as White Ivory Grey Fume Red Brown laid on 20 mm thick cement mortar 1 4 1 Cement 4 Coarse sand Jointing with grey cement slurry at 3 3 kg m2 including pointing the joints with white cement and matching pigment etc complete P No 63 I No 9 9 of PWD SR 2021 22

code17 - Supplying and errection of RCC rings for well steining of 0 3 Mtr Depth using M 20 grade concrete using clean graded granite or trap or jelly of approved quality 20mm and down size well compacted including centering formwork and plastering for both faces with C M 1 3 proportion as per design using 6 50mm M S coil at the rate of 10 Kgs ring including cost of stee P No 99 I No 11 20 3 11 20 3 For 1 20m dia clear rings of steining thickness 0 075mm upto 18 M depth

code18 - Providing and fixing water closet squatting pan Indian type W C pan with 100 mm sand cast Iron P or S trap 10 litre low level white P V C flushing cistern including flush pipe with manually controlled device handle lever conforming to IS 7231 with all fittings and fixtures complete including cutting and making good the walls and floors wherever required P No 123 I No 14 1 1 White Vitreous china Orissa pattern W C pan of size 580x440 mm with integral type foot rests

code19 - Providing and fixing wash basin with C I brackets 15 mm dia CP Brass single hole basin mixer of approved quality and make including painting of fittings and brackets cutting and making good the walls wherever required using White Vitreous China Wash basin size 550x400 mm with a 15 mm CP Brass single hole basin mixer P No 125 I No 14 7A

code20 - Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm and 340x410x265 mm sizes respectively with automatic flushing cistern with standard flush pipe and C P brass spreaders with brass unions and G I clamps complete including painting of fittings and brackets cutting and making good the walls and floors wherever required P No 123 I No 14 4 1 One urinal basin with 5 litre white P V C automatic flushing cistern

code21 - 110mm Outer Dia 2kg Sqm Pressure pipe of approved make PVC P No XXII I no 575

code22 - Tap

code23 - Gate Valve 20mm nominal Gun Bore metal P XXIV I No 657

code24 - Providing and placing on terrace at all Floor levels polyethylene water storage tanks IS 12701 marked with cover and suitable locking arrangements making necessary holes for inlet outlet and over flow pipes but without fittings and base support for tank 2023 24 PWD SR Vol 2 page No 123 item No 13 34