Rural Development And Panchayat Raj Department Tender

Pred04 - Providing laying spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness hand packing rolling with vibratory roller in stages to proper grade and camber applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate watering and compacting to the required density. PWD SR2023-24 Volume-3 P.26 SI.NO.4.14 B ii b

Pred05 - Providing and constructing un-reinforced plain cement concrete pavement thickness as per design over a prepared sub base with 43 grade cement or any other type as per Clause 1501.2.2 M30 Grade coarse and fine aggregates conforming to IS:383:2016: maximum size of coarse aggregate not exceeding 25 mm mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design laid in approved fixed side formwork steel channel laying and fixing of 125 micron thick polythene film wedges steel plates including levelling the formwork as per drawing spreading the concrete with shovels rakes compacted using needle screed and plate vibrators and finished in continuous operation including construction joints primer sealant curing of concrete slabs for 14-days and water finishing to lines and grade as per drawing and technical specification clause 1501 with all lead lifts loading and unloading charges cost and conveyance of all materials labour equipments etc. complete. as per the directions of the Engineer-in-charge of the work. PWD SR2023-24 Volume-3 P.149 SI.NO.16.28

Pred06 - Providing Vertical Delineator having wide angle cube corner micro prismatic non metallic reflective sheeting confirming to Type XI of ASTM D4956 -09 with White Color and Red Color combination and having minimum of retro reflective exposed area of 125 Sq CM on top slots and 35 cm2 on bottom slots and no edges shall be exposed for tampering. This tubular delineator shall have a core and shell construction shell shall be made of tough high impact resistant injection-molded thermoplastic outer body and the inner core shall consist of powder coated or painted Mild steel of minimum thickness 1.0mm.and core shell structure shall be of height not less than 800 mm above the ground and width not less than 80 mm. The metallic core of the delineator shall extend 300mm beyond the shell length from bottom for installing in the ground. The extended portion shall have slots to insert anchoring rods for enhancing the concrete grip. The logo of the manufacturer shall be embossed on either side of the body in the injection molding process. The engineering thermoplastic used for making the delineator body shall have minimum initial mechanical properties of be fixed by a combination of epoxy adhesive and grouting as per MoRTH specification 806 PWD SR2023-24 Volume-3 P.75 SI.NO. 8.45