Rural Development And Panchayat Raj Department Tender

code04 - Construction of Granular Sub-Base of required grading as per design mixing in a mechanical mix plant at OMC, carriage of mixed Material to work site, spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to achieve the esired density, complete as per clause 401

code05 - Laying Cement Concrete Pipe NP3 (burried conduits) on first class bedding of granular material including fixing collar with cement sand mortar 1:2 but excluding excavation, protection works, backfilling, concrete and masonary work in head wall and parapets

code06 - Providing and constructing un-reinforced plain cementconcrete pavement, thickness as per design, over aprepared sub base, with 43 grade cement or any othertype as per Clause 1501.2.2 M20 (Grade), coarse andfine aggregates conforming to IS:383, maximum sizeof coarse aggregate not exceeding 25 mm, mixed ina concrete mixer of not less than 0.2 m3 capacity andappropriate weigh batcher using approved mix design,laid in approved fixed side formwork (steel channel,laying and fixing of 125 micron thick polythene film,wedges, steelplates including levelling the formwork asper drawing), spreading the concrete with shovels, rakes,compacted using needle, screed and plate vibrators andfinished in continuousoperation including constructionjoints, primer, sealant , curing of concrete slabs for 14-days, and water finishing to lines and grade as per drawingand technical specificationclause 1501 with all lead, lifts,loading & unloading charges, cost and conveyance of allmaterials, labour, equipments etc., complete. as per thedirections of the Engineer-in-charge of the work

code07 - Providing and laying 80mm thick factory made precast M -30 grade Cement Concrete Paver Block as per IRC SP 63:2018 & IS 15658 for Cycle Tracks & Pedestrian Footpaths of approved shape and colour, laid in required pattern and including over 30mm thick compacted bed of coarse sand, filling the joints with fine sand etc. all complete as per the direction of Engineer-in charge. (WMM/WBM Base to be paid separately if necessary as per relevant technical specification)

code08 - Providing and applying tack coat with RS1 Bituminous Emulsion using emulsion pressure distributor at the rate of 0.20 kg/m2 on the prepared bituminous surface cleaned with mechanical broom

code09 - Mix Seal Surfacing Providing, laying and rolling of Close-Graded Premix Carpet (OGPC) surfacing material by Manual Means of 20 mm thickness composed 13.2 mm to 0.9 mm (Type-B) aggregates using VG30 bitumen to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 8-10 kN static roller and finishing to required level and grades as per Technical Specification