Karnataka Power Transmission Corporation Limited Tender

LS4 - Tower Accessories: a) Supplying and fixing GI angle 45X45x5 mm 1Mtr length with cleats, bolts nuts as per specification and fixing above 0.5mts length each at inner and outer surface of tower to facilitate running of barbed wire AC device

LS5 - b) Supplying and fixing of Barbed wire as per the specification.

LS6 - c) Number Plates (1 No. per tower)

LS7 - d) Danger Board (1 No. per tower)

LS8 - e) Circuit Plates (1 No. per circuit)

LS9 - f) Phase Plates (Set of 3 Nos.)

LS10 - g) Earth Bonds 450mm long

LS11 - i) Grounding of tower including cost of 40mm dia, 2.5mm thick, class 'C' GI pipe of 3mtrs length as per specifications with 50x6 GI flats 3 mtrs long, salt, charcoal.

LS12 - Conductor and Ground Wire: 1) Lynx ACSR

LS13 - 2) Ground Wire-7/3.15mm

LS14 - Insulators strings suitable for Lynx ACSR i) Single Tension insulator strings consisting of any one of the following: a) Insulator string consisting of 1X8nos. of 90KN Disc insulators Or b) Porcelain long rod insulator string equivalent to 1X8nos. of 90KN Disc insulators Or c) Silicon rubber composite insulator equivalent to 1X8nos. of 90KN Disc insulators NOTE: All the Insulator strings and hardware fittings quoted by the bidder shall be of the same type i.e. all the Insulator strings and hardware fittings shall be of Disc Insulators type OR all the Insulator strings and hardware fittings shall be of Polymeric Composite Insulators type OR all the Insulator strings and hardware fittings shall be of Long rod insulator. Bidder shall quote either for Disc Insulators type OR for Composite Insulators type OR for Long rod insulator and not for all the types.

LS15 - Insulator Hardwares for Lynx ACSR CONDUCTOR: i) Compression type Single Tension clamp (excluding Insulators) with hardwares & arcing horns suitable for Lynx ACSR conductor and suitable for 1X8 units of 90KN Disc insulators or equivalent.

LS16 - ii) Compression type Double Tension clamp (excluding Insulators) with hardwares & arcing horns suitable Lynx ACSR conductor and suitable for 2X8 units of 90KN Disc insulators or equivalent.

LS17 - Accessories for Lynx ACSR Conductors a) Mid Span Compression Joints

LS18 - b) Repair sleeves

LS19 - c) P G Clamps suitable for Lynx ACSR

LS20 - d) Vibration dampers

LS21 - Hardware and Accessories for Ground Wire: a) Mid Span Compression Joints

LS22 - b) Repair sleeves

LS23 - c) P G Clamps

LS24 - d) Single Tension Clamps(bolted type)