Directorate Of Municipal Administration Tender

code01 - Operation and Maintenance of light sources mentioned below as l(a) to (d) and (2) and cost of men and material as directed by the Engineer in-charge. Here the work includes supply and replacement of all components/materials such as lamps, chokes /ballasts, starters, condensers, ignitors, side holders, wire etc., complete for the street lighting as per the specifications mentioned below, including painting of poles and footings, pole numbering and preparing of master register for each ward/division, . removing of buntings, posters, threads, banners from the street lighting poles. Direct, tapping, Bimetal and all other nature of faults etc., to be attended by the contractor at his cost only. 4 feet, 36 W fluorescent lamp fixtures consisting of 4' long, 36W tube light as specified by IS 2418 (Part I, 11, Ill and IV), starter as per IS 2215 - 1968 and ballasts as per IS 1534 (Part 1) - 1967. The ballasts shall be legibly marked for origin, type, wiring diagram, ISi certification. For more details of these parts, please refer respected clauses under Technical Bid Form D-4. order No.UDO 36 PR) 2010 Bangalore Dated 31/3/2010

code02 - Operation and Maintenance of light sources mentioned below as l(a) to (d) and (2) and cost of men and material as directed by the Engineer in-charge. Here the work includes supply and replacement of all components/materials such as lamps, chokes /ballasts, starters, condensers, ignitors, side holders, wire etc., complete for the street lighting as per the specifications mentioned below, including painting of poles and footings, pole numbering and preparing of master register for each ward/division, . removing of buntings, posters, threads, banners from the street lighting poles. Direct, tapping, Bimetal and all other nature of faults etc., to be attended by the contractor at his cost only. HPSV 250W Lamp Fixtures should be of single piece gravity die cast LM6 alloy, ISi marked street light luminaries suitable for watt elliptical high pressure sodium lamp made by gravity die cast aluminium housing. High transparent acrylic bowl firmly held with the canopy by means of stainless steel toggles and rubber, gasket Optical control is provided by reflectors. The control gear housing accommodates low loss heavy duty polyester filled copper wire wound ballast, powerfactor improvement capacitor and igniter (for HPSV lamp) all pre wired up to the terminal block. The luminary is painted white inside and hammer tone gray out side. The luminaries meet IP-65 protection and confirm to IS: 10322 (part5/sec3) specifications but without lamp. For more details order

code03 - Operation and Maintenance of light sources mentioned below as l(a) to (d) and (2) and cost of men and material as directed by the Engineer in-charge. Here the work includes supply and replacement of all components/materials such as lamps, chokes /ballasts, starters, condensers, ignitors, side holders, wire etc., complete for the street lighting as per the specifications mentioned below, including painting of poles and footings, pole numbering and preparing of master register for each ward/division, . removing of buntings, posters, threads, banners from the street lighting poles. Direct, tapping, Bimetal and all other nature of faults etc., to be attended by the contractor at his cost only. LED Streetlight sources mentioned below and cost of men and material as directed by the engineer in charge. Here the work includes supply and replacement of all components/ materials such as lamps, chokes/ ballasta, holders, wire, etc., complete for the street lighting as per the specifications mentioned below. LED STREETLIGHT 120 watts as specified by IS 2418 and IS certification as per Technical bid from D-4. Price for 1 year (Data approved Rate)