Directorate Of Municipal Administration Tender

JKD1 - Operation and Maintenance of light sources mentioned below and cost of men and material ladder vehicle etc as directed by the Engineer incharge Here the work includes supply and replacement of all components materials such as lamps chokes ballasts starters condensers ignitors side holders underground cable wire etc complete for the street lighting as per the specifications mentioned below including painting of poles and footings pole numbering and preparing of master register for each ward division removing of buntings posters threads banners from the street lighting poles Direct tapping Bimetal and all other nature of faults etc to be attended by the contractor at his cost only 250 Watt HPSV Lamp Fixtures should be of single piece gravity die cast LM6 alloy ISI marked street light luminaries suitable for watt elliptical high pressure so dium lamp made by gravity die cast aluminium housing High transparent acrylic bowl firmly held with the canopy by means of stainless steel toggles and rubber gasket Optical control is provided by reflectors The control gear housing accommodates low loss heavy duty polyester filled copper wire wound ballast power-factor improvement capacitor and igniter (for HPSV lamp) all pre wired up to the terminal block The luminary is painted white inside and hammer tone gray out side The luminaries meet IP65 protection and confirm to IS 10322 (part5 sec3) specifications but without lamp Operation and Maintenance of 250 Watts So dium Vapour lamp fittings for Street lights

JKD2 - Operation and Maintenance of light sources mentioned below and cost of men and material ladder vehicle etc as directed by the Engineer in-charge. Here the work includes supply and replacement of all components/materials such as lamps chokes /ballasts starters condensers, ignitors, side holders, underground cable wire etc complete for the street lighting as per the specifications mentioned below including painting of poles and footings pole numbering and preparing of master register for each ward/division removing of buntings posters threads banners from the street lighting poles. Direct tapping Bimetal and all other nature of faults etc to be attended by the contractor at his cost only. 250 Watt Metal Halide (MH) Lamp fixtures consist of metal halide lamp confirming to IS 9974 (part I and II) choke of heavy duty inductive polyester filled copper wound ballast suitable for MH lamps made from low loss silicon steel lamination and are wound with polyester based super enamelled copper wire with class F insulation on specially designed glass filled nylon bobbin and Ignitors suitable for MH lamps confirming to IS 9974

JKD3 - Operation and Maintenance of light sources mentioned below and cost of men and material ladder vehicle etc., as directed by the Engineer in-charge. Here the work includes supply and replacement of all components/materials such as lamps, chokes /ballasts, starters, condensers, ignitors, side holders, underground cable,wire etc., complete for the street lighting as per the specifications mentioned below, including painting of poles and footings, pole numbering and preparing of master register for each ward/division, removing of buntings, posters, threads, banners from the street lighting poles. Direct, tapping, Bimetal and all other nature of faults etc., to be attended by the contractor at his cost only. 400 Watt Metal Halide (MH) Lamp fixtures consist of metal halide lamp confirming to IS 9974 (part I and II), choke of heavy duty inductive polyester filled copper wound ballast suitable for MH lamps made from low loss silicon steel lamination and are wound with polyester based super enamelled copper wire with class F insulation on specially designed glass filled nylon bobbin and Ignitors suitable for MH lamps confirming to IS 9974