Bruhat Bengaluru Mahanagara Palike Tender

code04 - Providing and fixing pre cast solid cement concrete kerb stones made out of M20 witht top and bottom width 114 and 165 mm respectively, 400mm high and 450mm in length finished with CM 1:3 plastering and finishing cutting, including formwork,curing, including cost of all materials, labhour, hire charges of machinery, loading, unloading, lead and lift, trasportation etc., complete. as directed by the Engineer in Charge of the work

code05 - Applying priming coats with primer of approved brand and manufacture, having low VOC (Volatile Organic Compound) content. With water thinnable cement primer on wall surface having VOC content less than 50 grams/litre as per specifications and as per directions of Engineer in charge.

code06 - Providing one line dressing to granite stone slab/granite stone masonry as per specifications. as directed by the Engineer in Charge of the work

code07 - Painting two coats after filling the surface with synthetic enamel paint in all shades on new plastered concrete surfaces as directed by the Engineer in Charge of the work

code08 - Lead for disposal of earth shall be payable at Carriage rates (Lead & Lift) by mechanical means including loading and unloading up to 15kms as directed by the Engineer in Charge of the work

code09 - Providing and constructing un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including construction joints, primer, sealant , curing of concrete slabs for 14-days, and water finishing to lines and grade as per drawing and technical specification clause 1501 with all lead, lifts, loading & unloading charges, cost and conveyance of all materials, labour, equipments etc., complete. as per the directions of the Engineer-in-charge of the work.

code10 - Supply of Hydraulic Excavator of 0.9 m3 bucket on hire basis including operator, fuel and other incidental charges etc., complete as directed by the Engineer in Charge of the work

code11 - Supply of Tipper-5.5 m3 on hire basis including operator, fuel and other incidental charges etc., complete as directed by the Engineer in Charge of the work

code12 - Supply of Joint cutting machine on hire basis including operator and other incidental charges etc., complete as directed by the Engineer in Charge of the work

code13 - Supply of Material component M-Sand - Fine for all road works.

code14 - Supply of Material component Granular Aggregates of 12mm downsize for all road works. as directed by the Engineer in Charge of the work

code15 - Supply of Material component Granular Aggregates of 20mm downsize for all road works. as directed by the Engineer in Charge of the work

code16 - Supply of Material component Granular Aggregates of 40mm downsize for all road works. as directed by the Engineer in Charge of the work

code17 - Supply of Material component Cement (OPC/PPC/PSC) for all road works. as directed by the Engineer in Charge of the work