Bruhat Bengaluru Mahanagara Palike Tender

code01 - DIESEL GENERATOR SET Supplying, installing, testing and commissioning of Diesel Generator set with following specifications. Power rating as per standard reference condition as per-BS 5514/ISO 3046/ ISO 8528 & IS 1002/ISO 3046 Generator set specifications. Engine:Diesel generatingset are ratedat 1500RPM and conform to ISO8528 specifications.The engines are radiator cooled, four stroke and multi cylinder, conforming to ISO3046.The scope of supply includes: Electrical starter motor12V DC Battery charging alternator, Bosch fuel system with mechanical governor, A1Class. Spin-on lubeoil filter,Spin-ondual fuel filter with water separator, Turbocharger, Charge air cooler, Silencer (Hospital grade), Dry type air cleaner, Shutoff coil, Flywheel and flywheel housing, First fill of lubeoil andcoolant, Safety for lowlube oil pressure, Safety for high water temperature, Permissible overload of 10% for one hour in 12 hours of operation Capacity of Fuel Tank: Fuel tank suitable for 8 hours of operation Alternator: Alternator is suitable for operation at 1500RPM, 415V, 0.8pf (lag) suitable for 50Hz, 3 phase, 4 wire systems, conforming to IS/IEC 60034-1. The Alternator is brush less type, screen protected, revolving field, self excited, self regulated through an AVR. The alternator shall have Plus or minus 1.0%Voltage regulation (max) instatic conditions- IP: 23 protections with insulation class F&H. Mounting arrangement: Engine and alternator aremounted on a common MS fabricated base frame with AVM pads.Control Panel:The control panel is manufactured with 14/16 gauge CRCA sheet and is powder coated for weather-proof and long lasting finish.The control panel consists of the following parts:-PS0500 Controller, Aluminium bus bars with suitable capacity within/outgoing terminals, Indicating lA for 'Load On' and 'Set Running', Instrument fuses duly wired and ferruled, MCCB of suitable rating with overload and short circuit protections. Genset Controller: microprocessor based generator set monitoring and control system. The control provides asimple operator interface to the generator set, manual and remote start/ stop control, shutdown fault indication, and an LCD hour counter. The integration of all functions into a single control system provides enhanced reliability and performance compared to conventional generator set control systems. This control has beendesigned and tested tomeet harsh environment inwhich gensets are typically applied. Features, Functions, protections 16 character x 2 line alphanumeric LCD display with LED Backlight The complete set shall have sufficient safety and adhere to NEC, NBC2016, IEC, CPWD specifications, PCB norms and KSGEI Acts and Rules.30KVA/24kw (detailed in Hard Copy)

code02 - Supply, Erection, testing and commissioning of AMF panel suitable for .....kVA DG set. The panel is of cubical type base/floor mounting control panel with hinged doors, undrilled bottom gland plate, aluminium Bus Bar with the accommodation for .....A 4 pole contactor for alternator with thermal O/L relay,.....A 4 pole contactor formains, HRC fuse for short circuit protection, Microprocessor based AMF module with supply failure timer, Restoration timer, 3 impulse automatic engine start/stop logic,Mains/generator voltage, .... capacity bypass switch and frequency sensing, PCC 1301 controller with water temperature/ Lubeoilpressure/ engine speed, Voltage/ ampere/ Frequency/ kVA, Running-hourcount, No of starts, Fault indication, over / under speed, Fails to start, Lowoil pleasure, High engine temperature, Under/ over voltage, over current, Earth faultrelay, with indications for Mainson, Loadon Mains, Battery charger on Push buttons AMF module by pass Mode, Battery charger unit with in built Auto /Manual and Flat/Boost facility.The complete set shallhave sufficient safety and adhere to NEC, NBC 2016, IEC, CPWD specifications, PCB norms and KSGEI Acts and Rules.15 KVA to 30 KVA

code03 - Laying of cable in Existing Trench/GI pipe/Stone Ware/RCC Hume pipe using Wooden/Aluminum Rollers as directed by the departmental staff LT Cable 2.5 to 25 Sqmm