Bangalore Electricity Supply Company Limited Tender

code01 - Supplying,installing,testingandcommissioning ofDiesel Generator set with following specifications. Power rating as per standard reference condition as per-BS5514/ISO3046/ISO 8528 & IS 1002/ISO 3046 Generator set specifications. Engine:Dieselgenerating set areratedat 1500RPMand conform to ISO8528 specifications. The engine s are radiator cooled,four stroke and multicylinder,conforming to ISO 3046.The scope of supply includes:Electrical starter motor12V DC Battery charging alternator, Bosch fuel system with mechanical governor, A1Class.Spin-on lube oil filter,Spin-on dual fuel filter with water separator,Turbo charger,Charge air cooler, Silencer (Hospita lgrade),Dry type air cleaner, Shut off coil,Fly wheel and fly wheel housing,First fill of lube oilandcoolant,Safety for low lube oil pressure,Safety for high water temperature,Permissible over load of 10% for one hour in 12 hours of operation. Capacity of Fuel Tank:Fuel tank suitable for 8hours of operation Alternator:Alternator is suitable for operation at1500 RPM, 5V,0.8pf(lag) suitable for 50Hz, 3phase, 4 wire systems, conforming to IS/ IEC60034-1.The Alternat or is brush less type,screen protected, revolving field, self excited, self regulated through an AVR. 62.5kva/50kw

code02 - Supply, Erection, testing and commissioning of AMF panel suitable for .....kVA DG set. The panel is of cubical type base/floor mounting control panel with hinged doors, undrilled bottom gland plate, aluminium Bus Bar with the accommodation for .....A4 pole contactor for alternat or with thermal O/L relay,.....A4 pole contactor for mains, HRC fuse for short circuit protection, Microprocessor based AMF module with supply failure timer, Restoration timer, 3 impulse automatic engine start/stop logic, Mains/ generator voltage, ....capacity bypass switch and frequency sensing, PCC 1301controller with water temperature/ Lube oil pressure/ engine speed,Voltage / ampere/ Frequency/ kVA, Running-hour count, No of starts, Fault indication, over/ underspeed, Fails to start, Low oil pleasure, Highengine temperature, Under/over voltage, over current, Earth fault relay, with indications for Mains on, Load on Mains, Battery charger on Push buttons AMF module by pass Mode, Battery charger unit with inbuilt Auto/ Manual and Flat/ Boost facility. The complete set shall have sufficient safety and adhere to NEC, NBC 2016, IEC, CPWD specifications, PCB norms and KSGEI Acts and Rules.62.5 KVA

code03 - 1.1 kV, XLPE or Heat resistant PVC insulated, PVC exutruted Inner Seath Armoured LTUG Cable as per IS-1554 (Part1) or IS-7098 Part-1, Armouring strip thickness and resistivity as per IS-3975 50 Sqmm, 4 Core, (17 GI Strips - 4 x 0.8 mm)