Urban Development Department Tender

Providing designation 75 A one brick edge soling joints filled with local sand including cost of watering taxes royalty all complete as per building specification and direction of E/I.

Providing and laying in position cement concorete specified grade of excluding the cost of centering,shuttering,finishing and reinforcement all work up to plinth level. 1:1.5:3(1 cement:1.5 coarse sand (zone III):3 gradeed stone aggregate 20mm nominal size)

Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centering,shuttering,finishing and reinforcement all work up to plinth level. 1:1.5:3(1 cement:1.5 coarse sand (zone III):3 gradeed stone aggregate 20mm nominal size)

Providing designation 75 A brick work in C.M. (1:6) in foundation and plinth with approved quality of clean coarse sand of F.M. 2 to 2.5 including providing 10mm thick mortar joints, cost of screening materials, raking out joints to 15mm depth, curing, taxes and royalty all complete as per building specification and direction of E/l.

Providing 12 mm thick cement plaster (1:6) with clean coarse sand of F.M. 1.5 including screening,curing with all leads and lifts of water,scaffolding ,taxes and royalty all complete as per building specification and direction of E/I.

Providing 1.5 mm cement punning including curing,carriage of water with all leads and lifts as per building specification and direction of E/I

Centering and shuttering including strutting,propping etc and removal of form for walls (any thickness) including attached pilasters,butteresses,plinth and string courses etc.

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, curing of concrete slabs for 14- days S.O.R. Item No. 6.4

Providing tor steel reinforcement of 10mm,12mm & 16mm dia. Bars as per approved design and drawing excluding carriage of bars to work site, cutting, bending, and binding with annealed wire with cost of wire, removal of rust, placing the rods in position all complete as per building specification and direction of E/I.

Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50mm thick compacted bed of sand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. 80 mm thick C.C. paver block of M-30 grade with approved color design and pattern.

Carriage of Materials (A) Cement & Steel (Lead upto 1 KM)

(B) Sand (Lead upto 8 KM)

(C) Chips (Lead upto 8 KM)

(d )disposal of earth (lead upto 3 km)

(E) Bricks (Lead upto 8 KM)

Add GST 18%

Add 1% Labour Cess (+)