Urban Development Department Tender

Providing and laying in position specified grade of reinforced cement concrete ,excluing the cost of centering, shuttering,finishing and reinforcement -all work up to plinth level. 1:1.5:3 (1cement: 1.5 coarse sand (zone -III): 3 graded stone aggregate 20 mm. nominal size)

Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401.

Providing designation 75 A one brick edge soling joints filled with local sand including cost of watering taxes royalty all complete as per building specification and direction of E/I.

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, curing of concrete slabs for 14- days S.O.R. Item No. 6.4

Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50mm thick compacted bed of sand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. 80 mm thick C.C. paver block of M-30 grade with approved color design and pattern.

Centering and shuttering including struting,propping etc. and removal of form for foundations,footings,bases of columns , etc. for mass concrete.

Providing Tor steel reinforcement of 8mm/10mm/12mm dia rods as per approved design and drawing excluding carriage of M.S. rods (straight or in coils) to work site cutting bending and binding with annealed wire with cost of wire removel of rust, placing the rods in position all complete as per building specification and direction of E/I.

Carriage of Materials :-

Disposal of earth (lead 3km)

Sand (Lead -8 K.M)

Bricks (Lead - 8K.M)

Chips (Lead - 11 K.M)

Cement and steel (Lead - 2 K.M)

Add 18% GST (+)

Add 1% Labour Cess (+)