Urban Development Department Tender
Search from across the categories, cities, and authorities to find the latest Jharkhand tenders. Every Jharkhand tender is curated from credible sources of government websites (eProcurement Jharkhand portal) and newspapers, thus ensuring the credibility of the information presented to you. For more information on Jharkhand tender bidder registration, the login process and more read the FAQs section on this page.
Costs
EMD
₹ 17,98,398Document Cost
₹ 25,000Tender Fee
Refer Documents
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2020_UDD_44216_1Bid Award Id
ViewTender No
DMC/73/11/2019-20Tender Authority
Urban Development Department ViewPurchaser Address
-Website
http://http://juidco.jharkhand.gov.in/
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
Construction of Subgrade and Earthen Shoulders (Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2)
6195.13
-
466.95
Loosening, Levelling & compacting original ground supporting embankment to facilitate placement of first layer of embankment, scarified to a depth of 150 mm mixed with water at OMC and then compacted by rolling so as to achieve minimum dry density as given in Tablr 300-2 for embankment construction
2606.02
-
44
Granular Sub-Base with Coarse Graded Material ( Table:- 400- 2) (Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401)
4199.3
-
1712.44
Wet Mix Macadam (Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.)
3578.5
-
1915.17
Prime coat (Providing and applying primer coat with bitumen emulsion on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.60 kg/sqm using mechanical means.)
21034
-
28.48
Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom.
(i) On granular surface treated with primer
14314
-
10.16
(ii) On Bituminous surface
23025
-
10.16
Dense Graded Bituminous Macadam (Providing and laying dense bituminous macadam with 100-120 TPH batch type HMP producing an average output of 75 tonnes per hour using crushed aggregates of specified grading, premixed with bituminous binder @ 4.0 to 4.5% by weight of total mix of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 507 complete in all respects.)
1381.5
-
7393.56
Semi - Dense Bituminous Concrete (Providing and laying semi dense bituminous concrete with 100-120 TPH batch type HMP producing an average output of 75 tonnes per hour using crushed aggregates of specified grading, premixed with bituminous binder @ 4.5 to 5 % of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled,vibratory and tandem rollers to achieve the desired compaction as per MoRTH specification clause No. 508 complete in all respects)
921
-
7566.72
Construction of dry lean cement concrete Sub-base over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 25 mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing.
524.3
-
2806
Cement Concrete Pavement M25 (Construction of un-reinforced, plain cement concrete pavement over a prepared sub base with 43 grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, Spread, compacted and finished in a continuous operation. Admixtures as approved, curing compound, finishing to lines and grades as per drawing )
1058.8
-
4767.05
Providing and laying sand filling under Paver blocks
553.65
-
1113.32
Supplying and Pre cast concrete blocks of M 35 grade and thickness not less than 80 mm for light traffic areas
3256.75
-
827.33
Excavation for Structures (Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material.)
204.98
-
60.48
Plain/Reinforced cement concrete in open foundation complete as per drawing and technical specifications i) PCC M15
21.62
-
4525.45
Plain/Reinforced cement concrete in open foundation complete as per drawing and technical specifications iv) RCC M30 (Using Batching Plant)
167.75
-
5195.26
Providing and fixing in position tar paper / craft paper bearing complete as per specification and as directed by the engineer
16.59
-
60
Providing weep holes in Brick masonry/Plain/Reinforced concrete abutment, wing wall/return wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1V :20H towards drawing foce. Complete as per drawing and Technical specifications
49
-
166.82
Supplying, fitting and placing un-coated HYSD bar reinforcement in foundation complete as per drawing and technical specifications
14.09
-
65190.09
Excavation for Structures (Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, construction of shoring and bracing, removal of stumps and other deleterious matter, dressing of sides and bottom and backfilling with approved material.)
3493.93
-
60.48
Plain/Reinforced cement concrete in open foundation complete as per drawing and technical specifications. (PCC grade M-15)
550.45
-
4525.45
Plain/Reinforced cement concrete in open foundation complete as per drawing and technical specifications (RCC Grade M 25) Using Batching plant
2211.96
-
5328.641075
Supplying, fitting and placing un-coated HYSD bar reinforcement in foundation complete as per drawing and technical specifications
186.28
-
65190.09
Providing gratings on lined drains complete as per drawings and technical specifications
1125
-
650
Providing weep holes in Brick masonry/Plain/Reinforced concrete abutment, drain wall, wing wall/return wall with 100 mm dia AC pipe, extending through the full width of the structure with slope of 1V :20H towards drawing foce. Complete as per drawing and Technical specifications
5542
-
166.82
Retro- reflectorised Traffic signs (Providing and fixing of retro- reflectorised cautionary,mandatory and informatory sign as per IRC :67 made of encapsulated lens type reflective sheeting vide clause 801.3, fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete 45 cm x 45 cm x 60 cm, 60 cm below ground level as per approved drawing)
(i) 90 cm Equilateral traingle
34
-
5416
(ii) 60 cm Circular
17
-
4730
(iii) 60 cm Equilateral traingle
17
-
3430
(iv) 60 cm x 60 cm Square
6
-
5518
Road Marking with Hot Applied Thermoplastic Compound with Reflectorising Glass Beads on Bituminous Surface (Providing and laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The finished surface to be level, uniform and free from streaks and holes.)
a) Lane/centre line/edge line/ transverse marking
920.9000000000001
-
548
Provision for Sign board & Photography
1
-
3000
Add 12% GST
79490718
-
0.12
Add 1% Labour Cess
89029604
-
0.01
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements