Jharkhand Industrial Area Development Authority Tender

Dense Graded Bituminous Macadam (Providing and laying dense bitumen macadam with 100-120TPH batch type HMP producing an avreage output of 75 tonnes per hour using crushed aggregate of specified grading, premixing with bituminous binder @4.0 to 4.5 % by weight of total mix mix and filler , transporting the hot mix to work site, laying with a hydrostatic paver finisher with senser control to the required grade, level and alignment, rolling with smooth wheeled, vibratry and tondem roller to achive the desired compaction as per morth specification clause no 507 complete in all respects.) with VG=30 Grade Bulk Bitumen. Add 1.0% for extra widening at curve & junction improvement.

Bituminous Concrete (Providing and laying bituminous concrete with 100-120 TPH batch type hot mix plant producing an avreage output of 75 tonns per hour using crushes aggregates of specified grading, premixing with bituminous binder @ 504 to 5.6 % of mix and filler transporting the hot mix to work site, laying with a hyrostatic paver finisher with sensor control to the required grade, level and alignment rolling with smooth wheeled, vibrating and tandem roller to achive the desired compaction as per morth specification clause No. 509.Comlete ain all respects.) Add 1.0% for extra widening at curve & junction improvement

Tack Caot Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20kg per sqm on the prepared bitumen/ granular surface cleaned with mechanical broom.Add 1.0% for extra widening at curve & junction improvement.

Filling in foundation trenches and plinth in layers not exceeding 150mm. Thick well watered, rammed, fully compacted and fine dressed with earth obtained after cutting within a lead of 50m and lift of 1.5 M all complete as per building specication and direction of E/I.

Road marking with hot Applied thermoplastic compound with refectorising Glass Beads on Bituminous surface (Providing and laying of hot applied thermoplastic compund 2.5mm thick including reflectorising glass beads @ gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to belevel ,uniform and free from streak and holes)

Solar Powered Road Marker (Solar Stud) Supplying of Solar Raised Pavement Markers made of polycarbonate molded body with circular shape, solar powered LED self illumination in active mode 360 degree illumination and reflective panels with micro prismatic lens capable of providing total internal reflection of the light entering the lens face in passive mode. The marker shall support a load of 20000 kg tested in accordance to ASTM D 4280. The marker should be resistant to dust and water ingress according to IP 65 standards and should withstand temperatures in the range of 0 C to 70 C. Colour of lighting could be provided in red or yellow (amber) as per requirement and typical frequency blinking in 1 Hz. There should be current losses of less than 20 microamperes at 2.4V in sleepcharging mode to enhance the life of the marker and a full charge should provide for a minimum autonomy of 50 hours. The height, width and length of the marker shall not be less than 10mmx100mmx100mm. Also, the surface diameter of the marker shall not be less than 100mm respectively. The weight of the marker shall not exceed 0.5 Kilograms. Fixing will be by drilling holes on the road for the shanks to go inside, without nails and using epoxy resin based adhesive and complete as directed by the engineer.)

GST

LABOUR CESS