Small Scale Industries Development Corporation Limited Tender

Providing and laying in position machine batched and machine mixed design mix M-25 grade cement concrete for reinforced cement concrete work, using cement content as per approved design mix, including pumping of concrete to site of alying but excluding the cost of centering, shuttering, finishing and reinforcement, including admixtures in recommended proportions as per IS: 9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability as per direction of Engineer-in charge. Note:- Cement in this item is @ 330kg/ Cum. Excess or less cement used as per design mix is content considered payable or recoverable separately. includes carriages complete

Reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete. Thermo- MechnicallyTreated bars. (All work at all levels complete) includes carriages complete

Providing from work including Centering, shuttering, strutting, Propping etc. using ply wood sheeting with water proofing ply board and removal of the same for (All work at all levels complete) includes carriages complete

Foundations, footings, bases of columns etc. for mass concrete

Column s, etc

Providing and fixing 230x75x20 mm thick exterior brick tiles having grooves more than 2mm. The tile should be silicon coated on front side of tile only to depth 5mm. The clay should be tunnel fired at over 1100 degree Celsius. Compressive strength500kg/cm, water absorption7%, colour natural shade etc. cement mortar 1:3 inclusive of all materials carriage lead and lifts etc. specifications/ selection done by Architect including carriage. Complete job (GRC Tiles Cladding) includes carriages complete

Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required. (For steel Gate Ornamental) as per the approved design by consultant/ Engineer Incharge including cost of necessary hold fasts and moving wheels, rails as required all compete as per the directions includes carriages complete

Providing retro-reflective regulatory sign board of size 900mm diameter made out of 2mm thick aluminum sheet, face to be fully covered with high intensity encapsulated lens type retro-reflective sheeting as approved by Engineer-in-charge. Letter, symbols, borders, etc. will be as per IRC:67 with required colour scheme on the boards and with the high intensity grade A. the aluminum sheet to be riveted to M.S frame of angle iron of size 40x40x4mm. The boards will be fixed to 1 No. 50x50mm, 4m long welded to the frame with adequate anti-theft arrangement. Sheet work to be painted with two or more coats of synthetic enamel paint over an under coat (primer) and back side of aluminum sheet to be painted with two or more coats of epoxy paint including appropriate priming coat complete in all respects as per direction of Engineer-in-charge. includes carriages complete

Finishing with Epoxy paint (two or more coats) at all locations prepared and applied as per manufacturers specifications including appropriate primer coat preparation of surface etc. complete.

Supplying, installation, testing and commissioning of Tubular pole of 10 meters height embedded in concrete block as per design including Flood lighting system/ all electric accessories complete in all respects includes carriages complete