Sher E Kashmir University Of Agricultural Sciences And Technology Tender

"Providing & laying in position cement concrete of specified grade excluding the cost of centering and shuttering all works upto plinth level.1:3: 6( 1 cement: 3 coarse sand: 6 graded stone agg/( 20mm nominal size) crushed aggregate) for mass concrete works."

Centering and shuttering including strutting, propping etc. and removal of form work for: Foundations, footings, bases for columns , Slabs Suspended Floor Etc.

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting , hoisting , fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. Hot finished welded type tubes

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Providing and fixing Track deck CRIL make or equivalent H.I. rib profiled sheets 1000 to 1020 mm cover width 28-35 mm high crests at 250 to 255 mm T.C.T(total coated thickness) high tensile S.M.P Galvalume steel. The sheets shall have wide panes with 3 no stiffing ribs, effective water shedding and special male/female ends with full return legs on side Lapps for purlins support and anti-capillary flute inside Lapp. The sheets shall have a hot dip metallic coated of zine and aluminum (150 gms /sm) zinc/aluminum coating mass total on both sides AZ-150 as IS - 1397,550 MPA yield stress. Providing silicon modified polyester coating of approved colour of total thickness of 35 micron comprising 20 micron exterior coat of S.M. over 5 micron polyester back coat over 5 micron primer coats on both surfaces including side and end Lapp and using 8mm Galvalume hex self-drilling fastener on each crest of sheet for connection with purlins and seam bolts at 300mm centers on all sides and end Lapps etc (.measured for unit of laid area) (0. 50 mm thickness )

Providing and fixing precoated galvanised steel sheet roofing accessories0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete : Ridges/valley plain (500 - 600mm)

Providing and fixing plained eaves boarding. 2nd class Kail Wood 300x40 mm (nominal size )

Brick Masonry with FPS bricks of class designation 75 in superstructure upto floor V level in cement mortar 1:6 ( 1 cement 6 fine sand ) complete in all respects

15mm Cement plaster on the rough side of single or half brick wall of mix 1 : 6 ( 1 cement : 6 coarse sand)

Applying priming coat: With ready mix primer of approved brand and manufacture:

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade. Two or more Coats on new work

Cement concrete flooring 1:2:4 (1 cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete. 50 mm thick with 20mm nominal size stone aggregate.

Providing and fixing strips in joints of terrazzo/ cement concrete floors Glass strips (40 mm wide and 4 mm thick)

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work complete in all respects.