Sher E Kashmir University Of Agricultural Sciences And Technology Tender

Gravel packing in tube well construction in accordance with IS: 4097, including providing gravel fine/ medium/ coarse, in required grading & sizes as per actual requirement, all complete as per direction of Engineer-in-charge.The Gravel should be Pea gravel which is used in bore well gravel packing works.Development of bore well with compressor till sand free water is available, including all sorts of labour charges as required at site for completion of bore well. including filter pipe,

P/f of HP submersible motor 2 hp Stage 14 Make Kirloskar or equivalent in Crompton Greaves. Complete in all respects with pump section etc and . Etc CAT No. Kirloskar KS4C-2014 #S450 LPM 90 at 36 Mtr Outlet size 38 mm

Providing of submersible 2 x 2.5 sq mm flat cable with rope as support copper Havels 1 core

HDPE pipe 40 Heavy type with etc with 4 lengths having perforation standard Dia 2.5" / 65 mm with Heavy Make Jindal /Prakash Surya

Bend / elbow GI 40 mm complete

Supplying, installation, testing & commissioning of 2 KW copper wound voltage stabilizer with following specification: 1. No. of input phases : Single 2. Frequency : 50HZ ± 3% 3. Capacity : 2 KW fitted with Voltmeter and ammeter 0-50A ( 1 Nos) AE make with roter switch, RYB indication primary and secondary brass terminals with oil 4. Input voltage: 90--200 5. Output: 220—200 6 with high cut and low cut protection. Make Chinar /Equivalent

MCB DP 32 A Make 2 pole 36 KA Hager /Legrand

S/I of Changeover , Panel Mounted Standard Make 32 Amp SPN

Supply installation testing and commissioning of DOL starter 3 HP range with features as below: MUG G 15FASD Heavy duty CAT No MU-Automatic DOL Starter or equivalent 4-6.5 A 1. Fully - Automatic type 3. Under voltage protection 4. Thermal overload protection 5. Single phase preventor protection Kilburn/Equivalent/L&T 8. Overload /under load protection The job includes mounting of starter on underneath panel board Complete with internal and external connections etc, Duly tested on load. MakeBentex / Kilburn / L&T

Fabrication, supply, installation, testing & commissioning of intdoor type compartmentalized feeder pillar having front area not less than 0.60 Sqmtr 600 mm x 600 mm) and depth 30 Cm (NS) made out of 2mm thick CRCA sheet having separate cable and bus bar alley, 1 door arrangement i/c locking arrangement, having 200 Amp four pole aluminium bus bar of full length with base frame made out of 50mmx50mmx6mm (thick) angle iron having 80cm legs for erection in ground with construction of cement concrete suitable foundation size complete with connections and interconnections with copper conductor PVC insulated cables/ insulated aluminium busbar strips of appropriate size and terminal blocks (on outgoing) including supplying & fixing following switchgears & accessories there in, powder coating, labelling, earthing etc. complete as required. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. with single phase preventer and MCB 32 A 2 Pole = 1 No , Over volatge relay , Shunt trip coil for MCCB , delay timer etc .

Cable 2.5 SQ mm for starter connection

Supply , laying of 1100 V 1 core 1 C 2x 4 sq mm copper cable 1100V XLPE un-armored cable in ground , walls ,ceiling trenches etc complete with clamp and saddle cable tags , markers , sand tiles /bricks etc

Earthing with GI earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required. With GI strip 25x5 mm etc . Complete in all respects

GI Nuts and bolts of size 80 MM with gas cut washers as required

Flat Iron Clamps of size 80 mm

20 mm flexible conduit

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work complete in all respects.