Sher E Kashmir University Of Agricultural Sciences And Technology Tender

Gravel packing in tube well construction in accordance with IS: 4097, including providing gravel fine/ medium/ coarse, in required grading & sizes as per actual requirement, all complete as per direction of Engineer-in-charge.The Gravel should be Pea gravel which is used in bore well gravel packing works. Development of bore well with compressor till sand free water is available, including all sorts of labour charges as required at site for completion of bore well.

P/f of 200 mm Shoe

P/f of HP submersible motor 15 hp Stage 7 Make Kirloskar or equivalent in Crompton Greaves. Complete in all respects with pump section etc and . Etc CAT No. Kirloskar KS6G-1507R LPM 720 @ 57 mtr Outlet size 100mm 34 A or Equivalent Make

Providing, laying, testing & commissioning of 'B' class medium duty G.l. pipe conforming to IS 1239 including welding, fittings like elbows, tees, flanges, tapers, nuts, bolts, gaskets etc. and fixing the pipe on the wall/ceiling with suitable clamp/support frame complete as required (DSR 2022 18.8.7) 100mm 1718/mtr

Bend / elbow GI 80/100 mm complete

SITC of Servo stabilizer of following specification: capacity:1. Capacity : 30 KVA 2. Input voltage: 155-460 V 3. Output: 415 Volts +/- 1 % 4. Winding Material : 99.9 % Pure copper wound strip with fibre glass 5. balanced type6. Dimmers with heat Sink based technology 7. Cooling : Oil Fresh IS 335 8. Micro Controller LCD True RMS with RS 485 Interface 9. Protection are overload, High Voltage, Under Voltage, Delay line, Single Phase , Preventive Neutral failure, through micro controller & L&T Make Connector 10. Display Parameters are KW, Current Power factor, Input, Output, Frequency, Trouble Shooting11. Auto Manual Selector switch with up/down switch in case card gets fault.12. Heavy duty Al, bus bar wiring input and output.13. Servo stabilizer tank shall be design in MS sheet Heavy gauge as suitable.14.Cooling of oil / Oil Level inlet, lifting huks etc 15. Earth terminal 16. Efficiency more than 98 % 17. Design as per IS 2026 981518. Multi function meters L&T Make19. Warranty 1 year. with single phase preventer

MCB TPN 100 A Make 4 pole 36 KA Hager /Legrand

S/I of Bypass Changeover , Panel Mounted Standard Make 100 Amp TPN

Supply installation testing and commissioning of star delta starter 30 HP range with features as below: MUG 30 S Heavy duty or equivalent 1. Fully - Automatic type 3. Under voltage protection 4. Thermal overload protection 5. Single phase preventor protection Kilburn/Equivalent/L&T 8. Overload /under load protection The job includes mounting of starter on underneath panel board Complete with internal and external connections etc, Duly tested on load. MakeBentex / Kilburn / L&T

Fabrication, supply, installation, testing & commissioning of intdoor type compartmentalized feeder pillar having front area not less than 0.60 Sqmtr 900 mm x 900 mm) and depth 30 Cm (NS) made out of 2mm thick CRCA sheet having separate cable and bus bar alley, 1 door arrangement i/c locking arrangement, having 200 Amp four pole aluminium bus bar of full length with base frame made out of 50mmx50mmx6mm (thick) angle iron having 80cm legs for erection in ground with construction of cement concrete suitable foundation size complete with connections and interconnections with copper conductor PVC insulated cables/ insulated aluminium busbar strips of appropriate size and terminal blocks (on outgoing) including supplying & fixing following switchgears & accessories there in, powder coating, labelling, earthing etc. complete as required. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. with single phase preventer with contactor and MCB 100 A 4 Pole = 1 No with high cut and low cut protection. and fitting of main MCCB and by pass changeover etc .

Cable 10 SQ mm for star to delta connection

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground including excavation and refilling the trench etc as required, but excluding sand cushioning and protective covering. DSR CODE 7.3.1 for 35 Sq mm

Supply , laying of 1100 V core 3.5 C 35 AYY XLPE 1100V XLPE un-armored cable in ground etc

Earthing with copper earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2. 7 metre long etc. with charcoal/ coke and salt as required.

Providing and fixing 25 mm X 5 mm copper strip on surface or in recess for connections etc. as required

GI Nuts and bolts of size 80 MM with gas cut washers as required

Flat Iron Clamps of size 80 mm

Threading of GI pipes for delivery section and cutting etc

32 mm PVC conduit

20 mm flexible conduit

S/I of valve 4 inches .Complete with welding works and fitting job.

S/I of T - GI 80/100 mm complete

Excavation for JCB work at site as required

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground including excavation and refilling the trench etc as required, but excluding sand cushioning and protective covering. DSR CODE 7.3.1 for 35 Sq mm

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work till complete in all respects.