Sher E Kashmir University Of Agricultural Sciences And Technology Tender

Supplying, assembling, lowering and fixing in vertical position in bore well, ERW (Electric Resistance Welded) FE 410 mild steel screwed and socketed plain ended casing pipes of 200mm nominal size dia having minimum wall thickness 7.1 or higher mm Heavy Grade marked as H , conforming to IS 3589 of reputed & approved make, including painted with outside surface with two coats of anticorrosive paint of approved brand and manufacture, as per relavant IS , including required hire & labour charges, fittings & accessories, all complete, for all depths. Note: The pipe shall be of TATA/JINDAL/ESSAR make. The work also inclusive the cost of welding charges and welding rod of approved IS code required for complete execution of the work mentioned in the Item.

Gravel packing in tube well construction in accordance with IS: 4097, including providing gravel fine/ medium/ coarse, in required grading & sizes as per actual requirement, all complete as per direction of Engineer-in-charge.The Gravel should be Pea gravel which is used in bore well gravel packing works.Development of bore well with compressor till sand free water is available, including all sorts of labour charges as required at site for completion of bore well.

P/f of 200 mm Shoe

P/f of HP submersible motor 12.5 hp Stage 5 Make Kirloskar or equivalent in Crompton Greaves. Complete in all respects with pump section etc and . Etc CAT No. Kirloskar KS8D-1305 500 LPM Outlet size 80mm

Providing of submersible 10 sq mm flat cable copper Havels 3 core

GI pipe C type with flange after every 10 ft length with welding etc with 4 lengths having perforation standard Dia 3 Inches with Heavy Make Jindal /Prakash Surya

Bend / elbow GI 80/100 mm complete

Supplying, installation, testing & commissioning of 20 KW copper wound voltage stabilizer with following specification:1. No. of input phases : Three2. Frequency : 50HZ ± 3%3. Capacity : 20 KW fitted with Voltmeter 0-50 (2-Nos) AE make with roter switch, RYB indication primary and secondary brass terminals with oil 4. Input voltage: 90--2005. Output: 220—200 PN, 400-440V P-P6. Oil Immersed with oil topping complete with high cut and low cut protection.Make Chinar /Equivalent

MCCB 125 A Make 4 pole 36 KA Hager /Legrand

S/I of Changeover , Panel Mounted Standard Make 100 Amp TPN

Supply installation testing and commissioning of star delta starter 20 HP range with features as below: MUG G 20 FASD CAT No SS95975DOFO or equivalent 1. Fully - Automatic type 3. Under voltage protection 4. Thermal overload protection 5. Single phase preventor protection Kilburn/Equivalent/L&T 8. Overload /under load protection The job includes mounting of starter on underneath panel board Complete with internal and external connections etc, Duly tested on load. Relay Range MakeBentex / Kilburn / L&T

Fabrication, supply, installation, testing & commissioning of intdoor type compartmentalized feeder pillar having front area not less than 0.60 Sqmtr 900 mm x 900 mm) and depth 30 Cm (NS) made out of 2mm thick CRCA sheet having separate cable and bus bar alley, 1 door arrangement i/c locking arrangement, having 200 Amp four pole aluminium bus bar of full length with base frame made out of 50mmx50mmx6mm (thick) angle iron having 80cm legs for erection in ground with construction of cement concrete suitable foundation size complete with connections and interconnections with copper conductor PVC insulated cables/ insulated aluminium busbar strips of appropriate size and terminal blocks (on outgoing) including supplying & fixing following switchgears & accessories there in, powder coating, labelling, earthing etc. complete as required. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. Providing and fixing following accessories in existing cubical panel board i/c making connection etc. as reqd. with single phase preventer and MCB 100 A 4 Pole = 1 No

2 X 10 sq. mm (19mm) termination

Cable 10 SQ mm for star to delta connection

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground including excavation and refilling the trench etc as required, but excluding sand cushioning and protective covering. DSR CODE 7.3.1 for 50 Sq mm

Supply , laying of 1100 V 1 core 3.5 C 50 AYY XLPE 1100V XLPE un-armored cable in ground , walls ,ceiling trenches etc complete with clamp and saddle cable tags , markers , sand tiles /bricks etc

Earthing with GI earth plate 600 mm X 600 mm X 3 mm thick including accessories, and providing masonry enclosure with cover plate having locking arrangement and watering pipe of 2.7 metre long etc. with charcoal/ coke and salt as required. With GI strip 25x5 mm etc . Complete in all respects

GI Nuts and bolts of size 80 MM with gas cut washers as required

Flat Iron Clamps of size 80 mm

Threading of GI pipes for delivery section and cutting etc

32 mm PVC conduit

20 mm flexible conduit

Fabrication of Shelter for Stabilizer , Control Panel of size 10x10 ftx 8 ft fabricated in Angle iron 50x50x5 mm with GI roofing etc , Cement concrete Platform above below ground 12 inches each , complete work in all respects .

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work till complete in all respects.