Sher E Kashmir University Of Agricultural Sciences And Technology Tender

Providing & laying in position cement concrete of specified grade excluding the cost of centering and shuttering all works upto plinth level 1:3: 6( 1 cement: 3 coarse sand: 6 graded stone agg/ 20mm nominal size) crushed aggregate) for mass concrete works.

Centering and shuttering including strutting, propping etc. and removal of form work up to all levels:(12 mm thick water proof ply)

Brick Masonry with FPS bricks of class designation 75 in superstructure upto floor V level in cement mortar 1:6 ( 1 cement 6 fine sand ) complete in all respects

Providing and laying in position 1:1½:3 (1 cement : 1½ coarse sand : 3 graded stone aggregate 20 mm nominal size) of reinforced cement concrete including curing but excluding the cost of centering, shuttering, finishing and reinforcement. All works upto all level

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto all level Thermo-Mechanically Treated bars of grade Fe-500D or more.

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately): First Class deodsr wood

Providing and fixing 35mm glazed shutters for doors, windows and clerestory windows using 4mm thick float glass panes including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws.First class kail wood

Providing and fixing 35mm wire gauze shutters using galvanized M.S. wire gauze of average width for aperture 1.4 mm in both directions with wire of dia. 0.63 mm for doors, windows and clerestory windows with ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws as per direction of Engineer-in-charge :First class kail wood

Providing and fixing Ornamental Panellled Door shutters (35mm thick) with ornamental paneles of Kail wood. With ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws.

15mm Cement plaster on the rough side of single or half brick wall of mix 1 : 6 ( 1 cement : 6 coarse sand)

10 mm Cement plaster on the rough side of single or half brick wall of mix 1 : 4 ( 1 cement : 6 coarse sand)

Pointing on brick masonry in lime surkhi (1 lime : 2 surkhi) including finshing the joints with lime surkhi pigment to give a heritage

Structural steel work in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete. Welded

Providing and fixing Track deck crill make or equivalent H.I. rib profiled sheets 1000 to 1020 mm cover width 28-35 mm high crests at 250 to 255 mm T.C.T(total coated thickness) high tensile S.M.P Galvalume steel. The sheets shall have wide panes with 3 no stiffing ribs, effective water shedding and special male/female ends with full return legs on side Lapps for purlins support and anti-capillary flute inside Lapp. The sheets shall have a hot dip metallic coated of zinc and aluminum (150 gms /sm) zinc/aluminum coating mass total on both sides AZ-150 as IS -1397 ,550 MPA yield stress. Providing silicon modified polyester coating of approved colour of total thickness of 35 micron comprising 20 micron exterior coat of S.M.P over 5 micron polyester back coat over 5 micron primer coats on both surfaces including side and end Lapp and using 8mm Galvalume hex self-drilling fastener on each crest of sheet for connection with purlins and seam bolts at 300mm centers on all sides and end Lapps etc (.measured for unit of laid area) (0.50 mm thickness )

(b) As per item above for plain .50mm total thickness SMP coated galvanised steelof similar material for ridge, caping pieces places at apex of sky lights/hips. Valleys etc incl. noteing turning down of edges of capping between ribs etc complete (500mm to 1000mm)

Providing and fixing plained finished eaves boarding. 2nd class kail wood 300x40 mm (nominal size)

Providing wood work in frames of false ceiling, partitions etc. sawn and fixed in position :Budloo

Providing and fixing PVC panelling 5mm thick (sapphire series) including beading, profiles etc all compleate.

Providing and applying white cement based putty of specified thickness, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.2 mm thick

Wall Painting with acrylic emulsion paint of approved brand and manufacture to give an even shade. Two or more coats on new work

Painting with synthetic enamel paint of approved brand and manufacture to give an even shade.Two or more coats on new work

Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface.

Applying priming coat With ready mixed pink or grey primer of approved brand and manufacture on wood work (hard and soft wood)

Providing 40x5 mm flat iron hold fast 40 cm long including fixing to frame with 10 mm diameter bolts, nuts and wooden plugs and embeddings in cement concrete block 30x10x15 cm 1:3:6 mix ( 1 cement : 3 coarse sand : 6 graded stone aggregate 20 mm nominal size).

Providing and fixing hardware fittings of approved brand and of required type as approved by Engineer Incharge/ consultant. (Aluminum Fittings of Antique Finish) complete as per the specifications

a)Sliding door bolt with locking arrangement (godrej)

b)Tower bolt size 125 mm)

(c)Handle 125 mm

(d)Tower bolt size 200 mm)

Note:-The rates quoted are inclusive of all carriages of materials (Mechanical/Manual) from source to site work and all extra charges including dewatering if any during the execution of work complete in all respects.